aboutsummaryrefslogtreecommitdiffstats
path: root/arch/x86_64/mm/init.c
Commit message (Collapse)AuthorAge
* [PATCH] x86/x86_64: mark rodata section read-only: x86-64 supportArjan van de Ven2006-01-06
| | | | | | | | | | x86-64 specific parts to make the .rodata section read only Signed-off-by: Arjan van de Ven <arjan@infradead.org> Signed-off-by: Ingo Molnar <mingo@elte.hu> Cc: Andi Kleen <ak@muc.de> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* [PATCH] x86_64: Fix incorrect node_present_pages on NUMARavikiran G Thirumalai2005-12-29
| | | | | | | | | | | | | | Currently, we do not pass the correct start_pfn to e820_hole_size, to calculate holes. Following patch fixes that. The bug results in incorrect number of node_present_pages for each pgdat and causes ugly output in /sys and probably VM inbalances. Signed-off-by: Alok N Kataria <alokk@calsoftinc.com> Signed-off-by: Ravikiran Thirumalai <kiran@scalex86.org> Signed-off-by: Andi Kleen <ak@suse.de> Sighed-off-by: Shair Fultheim <shai@scalex86.org> Sighed-off-by: Linus Torvalds <torvalds@osdl.org>
* [PATCH] x86_64: Remove CONFIG_CHECKING and add command line option for ↵Andi Kleen2005-11-14
| | | | | | | | | | | | | | | | | | | pagefault tracing CONFIG_CHECKING covered some debugging code used in the early times of the port. But it wasn't even SMP safe for quite some time and the bugs it checked for seem to be gone. This patch removes all the code to verify GS at kernel entry. There haven't been any new bugs in this area for a long time. Previously it also covered the sysctl for the page fault tracing. That didn't make much sense because that code was unconditionally compiled in. I made that a boot option now because it is typically only useful at boot. Signed-off-by: Andi Kleen <ak@suse.de> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* [PATCH] x86_64: Replace swiotlb extern with includeAndi Kleen2005-11-14
| | | | | | | Minor victory on the continuous quest against all stray extern. Signed-off-by: Andi Kleen <ak@suse.de> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* [PATCH] x86_64: Replace cpu_pda extern with includeAndi Kleen2005-11-14
| | | | | | | Minor cleanup - remove obsolete extern Signed-off-by: Andi Kleen <ak@suse.de> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* [PATCH] x86_64: Only use asm/sections.h to declare section symbolsAndi Kleen2005-11-14
| | | | | | | | | Adding __initdata_* to asm-generic/sections.h Replaces a lot of open coded externs in arch/x86_64/* I had to change __bss_end to __bss_stop to match the other architectures. Signed-off-by: Andi Kleen <ak@suse.de> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* [PATCH] x86_64: Unmap NULL during early bootupSiddha, Suresh B2005-11-14
| | | | | | | | | | | | | | | | | | We should zap the low mappings, as soon as possible, so that we can catch kernel bugs more effectively. Previously early boot had NULL mapped and didn't trap on NULL references. This patch introduces boot_level4_pgt, which will always have low identity addresses mapped. Druing boot, all the processors will use this as their level4 pgt. On BP, we will switch to init_level4_pgt as soon as we enter C code and zap the low mappings as soon as we are done with the usage of identity low mapped addresses. On AP's we will zap the low mappings as soon as we jump to C code. Signed-off-by: Suresh Siddha <suresh.b.siddha@intel.com> Signed-off-by: Ashok Raj <ashok.raj@intel.com> Signed-off-by: Andi Kleen <ak@suse.de> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* [PATCH] x86_64: Account mem_map in VM holes accountingAndi Kleen2005-11-14
| | | | | | | | | | | The VM needs to know about lost memory in zones to accurately balance dirty pages. This patch accounts mem_map in there too, which fixes a constant errror of a few percent. Also some other misc mappings and the kernel text itself are accounted too. Signed-off-by: Andi Kleen <ak@suse.de> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* [PATCH] x86_64: Add 4GB DMA32 zoneAndi Kleen2005-11-14
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | Add a new 4GB GFP_DMA32 zone between the GFP_DMA and GFP_NORMAL zones. As a bit of historical background: when the x86-64 port was originally designed we had some discussion if we should use a 16MB DMA zone like i386 or a 4GB DMA zone like IA64 or both. Both was ruled out at this point because it was in early 2.4 when VM is still quite shakey and had bad troubles even dealing with one DMA zone. We settled on the 16MB DMA zone mainly because we worried about older soundcards and the floppy. But this has always caused problems since then because device drivers had trouble getting enough DMA able memory. These days the VM works much better and the wide use of NUMA has proven it can deal with many zones successfully. So this patch adds both zones. This helps drivers who need a lot of memory below 4GB because their hardware is not accessing more (graphic drivers - proprietary and free ones, video frame buffer drivers, sound drivers etc.). Previously they could only use IOMMU+16MB GFP_DMA, which was not enough memory. Another common problem is that hardware who has full memory addressing for >4GB misses it for some control structures in memory (like transmit rings or other metadata). They tended to allocate memory in the 16MB GFP_DMA or the IOMMU/swiotlb then using pci_alloc_consistent, but that can tie up a lot of precious 16MB GFPDMA/IOMMU/swiotlb memory (even on AMD systems the IOMMU tends to be quite small) especially if you have many devices. With the new zone pci_alloc_consistent can just put this stuff into memory below 4GB which works better. One argument was still if the zone should be 4GB or 2GB. The main motivation for 2GB would be an unnamed not so unpopular hardware raid controller (mostly found in older machines from a particular four letter company) who has a strange 2GB restriction in firmware. But that one works ok with swiotlb/IOMMU anyways, so it doesn't really need GFP_DMA32. I chose 4GB to be compatible with IA64 and because it seems to be the most common restriction. The new zone is so far added only for x86-64. For other architectures who don't set up this new zone nothing changes. Architectures can set a compatibility define in Kconfig CONFIG_DMA_IS_DMA32 that will define GFP_DMA32 as GFP_DMA. Otherwise it's a nop because on 32bit architectures it's normally not needed because GFP_NORMAL (=0) is DMA able enough. One problem is still that GFP_DMA means different things on different architectures. e.g. some drivers used to have #ifdef ia64 use GFP_DMA (trusting it to be 4GB) #elif __x86_64__ (use other hacks like the swiotlb because 16MB is not enough) ... . This was quite ugly and is now obsolete. These should be now converted to use GFP_DMA32 unconditionally. I haven't done this yet. Or best only use pci_alloc_consistent/dma_alloc_coherent which will use GFP_DMA32 transparently. Signed-off-by: Andi Kleen <ak@suse.de> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* [PATCH] x86-64: Fix show_mem a little bitAndi Kleen2005-09-12
| | | | | | | | | - Add KERN_INFO to printks (from i386) - Use longs instead of ints to accumulate pages. - Fix broken indenting. Signed-off-by: Andi Kleen <ak@suse.de> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* [PATCH] x86-64: Remove redundant max_mapnr and replace with end_pfnAndi Kleen2005-09-12
| | | | | | | | The FLATMEM people added it, but there doesn't seem a good reason because end_pfn is identical. Signed-off-by: Andi Kleen <ak@suse.de> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* [PATCH] x86-64: Use e820_find_hole to compute reserved pagesAndi Kleen2005-09-12
| | | | | | | Avoids a very dumb loop Signed-off-by: Andi Kleen <ak@suse.de> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* [PATCH] x86-64: Remove redundant swiotlb=force handlingAndi Kleen2005-09-12
| | | | | | | It's already handled in the main swiotlb code. Signed-off-by: Andi Kleen <ak@suse.de> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* [PATCH] x86_64: Tell VM about holes in nodesAndi Kleen2005-08-26
| | | | | | | | | | | | | | | | | | | | | | | Some nodes can have large holes on x86-64. This fixes problems with the VM allowing too many dirty pages because it overestimates the number of available RAM in a node. In extreme cases you can end up with all RAM filled with dirty pages which can lead to deadlocks and other nasty behaviour. This patch just tells the VM about the known holes from e820. Reserved (like the kernel text or mem_map) is still not taken into account, but that should be only a few percent error now. Small detail is that the flat setup uses the NUMA free_area_init_node() now too because it offers more flexibility. (akpm: lotsa thanks to Martin for working this problem out) Cc: Martin Bligh <mbligh@mbligh.org> Signed-off-by: Andi Kleen <ak@suse.de> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* [PATCH] reorganize x86-64 NUMA and DISCONTIGMEM config optionsMatt Tolentino2005-06-23
| | | | | | | | | | | | | In order to use the alternative sparsemem implmentation for NUMA kernels, we need to reorganize the config options. This patch effectively abstracts out the CONFIG_DISCONTIGMEM options to CONFIG_NUMA in most cases. Thus, the discontigmem implementation may be employed as always, but the sparsemem implementation may be used alternatively. Signed-off-by: Matt Tolentino <matthew.e.tolentino@intel.com> Signed-off-by: Dave Hansen <haveblue@us.ibm.com> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* [PATCH] x86_64: Use a VMA for the 32bit vsyscallAndi Kleen2005-04-16
| | | | | | | | | | | | | Use a real VMA to map the 32bit vsyscall page This interacts better with Hugh's upcomming VMA walk optimization Also removes some ugly special cases. Code roughly modelled after the ppc64 vdso version from Ben Herrenschmidt. Signed-off-by: Andi Kleen <ak@suse.de> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* Linux-2.6.12-rc2v2.6.12-rc2Linus Torvalds2005-04-16
Initial git repository build. I'm not bothering with the full history, even though we have it. We can create a separate "historical" git archive of that later if we want to, and in the meantime it's about 3.2GB when imported into git - space that would just make the early git days unnecessarily complicated, when we don't have a lot of good infrastructure for it. Let it rip!