aboutsummaryrefslogtreecommitdiffstats
path: root/arch/arm/mach-omap2/i2c.c
Commit message (Collapse)AuthorAge
* ARM: 7159/1: OMAP: Introduce local common.h filesTony Lindgren2011-11-17
| | | | | | | | | | | As suggested by Russell King - ARM Linux <linux@arm.linux.org.uk>, there's no need to keep local prototypes in non-local headers. Add mach-omap1/common.h and mach-omap2/common.h and move the local prototypes there from plat/common.h and mach/omap4-common.h. Signed-off-by: Tony Lindgren <tony@atomide.com> Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
* OMAP: hwmod: fix the i2c-reset timeout during bootupAvinash.H.M2011-07-10
| | | | | | | | | | | | | | | | | | | | | | | | The sequence of _ocp_softreset doesn't work for i2c. The i2c module has a special sequence to reset the module. The sequence is - Disable the I2C. - Write to SOFTRESET bit. - Enable the I2C. - Poll on the RESETDONE bit. The sequence is implemented as a function and the i2c_class is updated with the correct 'reset' pointer. omap_hwmod_softreset function is implemented which triggers the softreset by writing into sysconfig register. On following this sequence, i2c module resets properly and timeouts are not seen. Cc: Rajendra Nayak <rnayak@ti.com> Cc: Paul Walmsley <paul@pwsan.com> Cc: Benoit Cousson <b-cousson@ti.com> Cc: Kevin Hilman <khilman@ti.com> Signed-off-by: Avinash.H.M <avinashhm@ti.com> [paul@pwsan.com: combined this patch with a patch to remove HWMOD_INIT_NO_RESET from the 44xx hwmod flags; change register offset conditional code to use the IP block revision; minor code cleanup] Signed-off-by: Paul Walmsley <paul@pwsan.com>
* omap: mux: Convert 2420 platform init code to use new mux codeTony Lindgren2010-07-05
| | | | | | Convert 2420 platform init code to use new mux code Signed-off-by: Tony Lindgren <tony@atomide.com>
* omap: i2c: Fix muxing for command line enabled busJarkko Nikula2010-02-25
| | | | | | | | | | | | The commit b63128e81214cc2db2995d690438055c26d213a5 broke the pin muxing for I2C busses that are enabled from the kernel command line. Fix this by defining the board registration function omap_register_i2c_bus in common platform code as it was before but keep the muxing in architecture dependent files. Signed-off-by: Jarkko Nikula <jhnikula@gmail.com> Signed-off-by: Tony Lindgren <tony@atomide.com>
* omap: Split i2c platform init for mach-omap1 and mach-omap2Tony Lindgren2009-12-11
Otherwise we cannot limit new mux code to mach-omap2. The same signal names should eventually work for other omaps under mach-omap2. Note that these pins don't need to be OMAP_PIN_INPUT_PULLUP, just OMAP_PIN_INPUT is enough. Cc: Jarkko Nikula <jhnikula@gmail.com> Signed-off-by: Tony Lindgren <tony@atomide.com>