aboutsummaryrefslogtreecommitdiffstats
path: root/arch/arm/mach-ixp4xx
Commit message (Collapse)AuthorAge
* [ARM] Fix IXDP425 setup bugJeff Hansen2005-12-01
| | | | | | | | There is a typo in the ARM IXDP425 setup definition that mistakenly tries to use UART1's IRQ for UART2's traffic. Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
* [ARM] 3140/1: NSLU2 machine supportAlessandro Zummo2005-11-10
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | Patch from Alessandro Zummo This patch adds support for the LinkSys NSLU2 running with both big and little-endian kernels. The LinkSys NSLU2 is a cost engineered ARM, XScale 420 based system similar to the the Intel IXDP425 evaluation board. It uses the IXP4XX ARCH. While this patch applies independently of other patches the resultant kernel requires further patches to successfully use onboard devices, including the onboard flash. Since these patches are independent of this one they will be submitted separately. A defconfig is not included here because not all of the required drivers are actually in the kernel. We intend to provide one as soon as the patches will be incorporated in mainstream. This patch is the combined work of nslu2-linux.org Signed-off-by: John Bowler <jbowler@acm.org> Signed-off-by: Alessandro Zummo <a.zummo@towertech.it> Signed-off-by: Deepak Saxena <dsaxena@plexity.net> Signed-off-by: Lennert Buytenhek <buytenh@wantstofly.org> Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
* [ARM] 3089/1: ixp4xx AHB/PCI endianness fixAlessandro Zummo2005-11-06
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | Patch from Alessandro Zummo This patch fixes AHB/PCI endianness problems when the processor is in little-endian mode. The patch configures the CSR register closely following the directives in [1], paragraph 4.1, page 19. According to the considerations in [1], page 11, while the AHB bus supports both endian modes, on the IXP4XX it always uses big-endian. The PCI bus is connected to the South AHB. A wrong setting in the CSR register will thus cause a malfunctional PCI bus. A schematic diagram of the bus interconnections on the IXP4XX can be found in [1], page 18. The patch has been verified to work on the NSLU2 in both LE and BE modes. The author is Peter Korsgaard. [1] Intel® IXP4XX Product Line of Network Processors and IXC1100 Control Plane Processor: Understanding Big Endian and Little Endian Modes http://www.intel.com/design/network/applnots/25423701.pdf Signed-off-by: Alessandro Zummo <a.zummo@towertech.it> Signed-off-by: Deepak Saxena <dsaxena@plexity.net> Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
* Create platform_device.h to contain all the platform device details.Russell King2005-10-29
| | | | | | | | Convert everyone who uses platform_bus_type to include linux/platform_device.h. Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk> Acked-by: Greg Kroah-Hartman <gregkh@suse.de>
* [ARM] 2985/1: Replace map_desc.physical with map_desc.pfn: IXP4xxDeepak Saxena2005-10-28
| | | | | | | | | Patch from Deepak Saxena IXP4xx map_desc.pfn conversion Signed-off-by: Deepak Saxena <dsaxena@plexity.net> Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
* [PATCH] Fix thinko in previous ARM 2917/1 patchDeepak Saxena2005-09-29
| | | | | | | Previous patch accidently add IXDP425 mach entry when IXDP465 is configured. Signed-off-by: Deepak Saxena <dsaxena@plexity.net> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* [ARM] 2935/1: ixp4xx: fix warnings in ixp4xx_set_irq_typeDavid Vrabel2005-09-26
| | | | | | | Patch from David Vrabel Signed-off-by: David Vrabel <dvrabel@arcom.com> Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
* [ARM] 2917/1: Make IXP4xx mach_desc's depend on config optionsDeepak Saxena2005-09-18
| | | | | | | | | | | | | | | | | Patch from Deepak Saxena Building a kernel for IXDP425 currently includes the machine descriptors for IXDP465 and PRPMC1100 even if those machines are not configured. This means we can build a kernel that boots on those machines even though the machine_is_xxx() macro will always return 0 and other bits such as PCI won't be compiled in. This can lead to many wasted hours wondering what you have done to your kernel to make it randomly crash thus requireing large quantities of beer to be consumed. While I am all for consumption of large quantities of beer, there are better reasons to do so then stupid kernel bugs. Signed-off-by: Deepak Saxena <dsaxena@plexity.net> Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
* [SERIAL] Use an enum for serial8250 platform device IDsRussell King2005-09-08
| | | | | | | | Rather than hard-coding the platform device IDs, enumerate them. We don't particularly care about the actual ID we get, just as long as they're unique. Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
* [ARM] Fix missed initialisers/missing commaRussell King2005-09-06
| | | | | | Fix the broken initialisers missed by the recent IRQ patch. Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
* [ARM] 2836/1: Cleanup IXP4xx GPIO codeDeepak Saxena2005-08-29
| | | | | | | | | | | | Patch from Deepak Saxena This patch implements the set_irq_type() hooks for configuring GPIO IRQ type and updates all the platforms to use it instead of the gpio_line_config() function which is now used to configure input vs. output on the pins. Signed-off-by: Deepak Saxena <dsaxena@plexity.net> Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
* [ARM] 2834/1: Remove IXP4xx board-specific map_io routinesDeepak Saxena2005-08-29
| | | | | | | | | Patch from Deepak Saxena None of the board-specific map_io routines do anything, so kill them. Signed-off-by: Deepak Saxena <dsaxena@plexity.net> Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
* [PATCH] arm: fix IXP4xx flash resource rangeDeepak Saxena2005-08-26
| | | | | | | | | | | | | We are currently reserving one byte more than actually needed by the flash device and overlapping into the next I/O expansion bus window. This a) causes us to allocate an extra page of VM due to ARM ioremap() alignment code and b) could cause problems if another driver tries to request the next expansion bus window. Signed-off-by: Deepak Saxena <dsaxena@plexity.net> Cc: Russell King <rmk@arm.linux.org.uk> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* [PATCH] ARM: 2835/1: Add UPF_SKIP_TEST to IXP4xx serial portsDeepak Saxena2005-08-03
| | | | | | | | | | | Patch from Deepak Saxena This allows the serial driver autconf to work properly on all the IXP serial ports. W/o it we basically put the serial port in an unrecoverable state and lose console. Signed-off-by: Deepak Saxena <dsaxena@plexity.net> Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
* [PATCH] ARM: 2792/1: IXP4xx iomap API implementationDeepak Saxena2005-07-06
| | | | | | | | | | | | | | | | Patch from Deepak Saxena This patch implements the iomap API for Intel IXP4xx NPU systems. We need to implement our own version of the API functions b/c of the PCI hostbridge does not provide the capability to map PCI I/O space into the CPU's physical memory space. In addition, if a system has more than 64M of PCI memory mapped BARs, PCI memory must also be accessed indirectly. This patch changes the assignment of PCI I/O resources to fall into to 0x0000:0xffff range so that we can trap I/O areas in our ioread/iowrite macros. Signed-off-by: Deepak Saxena Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
* [PATCH] ARM: 2790/1: Properly terminate plat_serial8250_port arrays on ↵Stefan Sorensen2005-07-06
| | | | | | | | | | | | | | ixdp425 and coyote Patch from Stefan Sorensen On the ixdp425 and coyote platforms, the plat_serial8250_port arrays are missing the terminating entry required by serial8250_probe. Signed-off-by: Stefan Sorensen <ssoe@kirktelecom.com> Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
* [PATCH] ARM: Remove machine description macrosRussell King2005-07-03
| | | | | | | Remove the pointless machine description macros, favouring C99 initialisers instead. Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
* [PATCH] ARM: Add SA_TIMER flag to timer interruptsRussell King2005-06-26
| | | | | | | VST needs to know which timer handler is for the timer interrupt. Mark all timer interrupts with the SA_TIMER flag. Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
* [PATCH] ARM: 2745/1: Fix IXP4xx debug macrosDeepak Saxena2005-06-24
| | | | | | | | | | | | | Patch from Deepak Saxena Current IXP4xx debug macros do not work in the small window between the MMU being enabled and the call to map_io() b/c the standard peripheral mapping is not properly setup for use with the low-level debug code. This patch creates a new section-aligned mapping for the UART specifically for use with the debug macros. Signed-off-by: Deepak Saxena Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
* [PATCH] PCI: drivers/pci/pci.c: remove pci_dac_set_dma_maskAdrian Bunk2005-05-04
| | | | | | | pci_dac_set_dma_mask is currently completely unused. Signed-off-by: Adrian Bunk <bunk@stusta.de> Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
* [PATCH] arm: fix help text for ixdp465akpm@osdl.org2005-04-16
| | | | | | | | | | | | | | | ) From: Russell King <rmk+lkml@arm.linux.org.uk> For some reason, this help text was missed when the file was last audited by the documentation referencing folk. Fix this incorrect documentation reference. Signed-off-by: Russell King <rmk@arm.linux.org.uk> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* Linux-2.6.12-rc2v2.6.12-rc2Linus Torvalds2005-04-16
Initial git repository build. I'm not bothering with the full history, even though we have it. We can create a separate "historical" git archive of that later if we want to, and in the meantime it's about 3.2GB when imported into git - space that would just make the early git days unnecessarily complicated, when we don't have a lot of good infrastructure for it. Let it rip!
generated by cgit v1.2.2 (git 2.25.0) at 2024-12-15 09:09:17 -0500