| Commit message (Expand) | Author | Age |
... | |
| * | mac80211_hwsim: Update documentation (AP mode enabled) | Jouni Malinen | 2008-11-21 |
| * | mac80211: rc80211_pid eliminate sparse warnings | Tomas Winkler | 2008-11-21 |
| * | rt2x00: Cleanup TX/RX entry handling | Ivo van Doorn | 2008-11-21 |
| * | mac80211: remove more excess kernel-doc | Randy Dunlap | 2008-11-21 |
| * | iwlwifi: use Rx single frame mode (one Rx frame per RB) | Zhu, Yi | 2008-11-21 |
| * | iwlwifi: get some more information about command failure | Winkler, Tomas | 2008-11-21 |
| * | iwl3945 : Simplify iwl3945_send_beacon_cmd | Kolekar, Abhijeet | 2008-11-21 |
| * | iwlwifi: move iwl_print_hex_dump to iwl-debug.h | Winkler, Tomas | 2008-11-21 |
| * | iwl3945 : Fix Sparse Warnings | Kolekar, Abhijeet | 2008-11-21 |
| * | iwlwifi: move spectrum measurement code to iwl-spectrum.c file | Tomas Winkler | 2008-11-21 |
| * | iwlwifi: revamp tx scheduler byte count tables handling | Tomas Winkler | 2008-11-21 |
| * | iwlwifi: move rx queue read pointer into rxq | Winkler, Tomas | 2008-11-21 |
| * | iwlwifi: update iwl-commands.h for 3 stream support | Halperin, Daniel C | 2008-11-21 |
| * | iwlwifi: don't fail power set when calibration is not done yet | Winkler, Tomas | 2008-11-21 |
| * | iwlwifi: trivial fix in includes | Winkler, Tomas | 2008-11-21 |
| * | iwl3945: fix resume for ADHOC network | Mohamed Abbas | 2008-11-21 |
| * | iwlagn: fix resume for ADHOC network | Mohamed Abbas | 2008-11-21 |
| * | b43: remove rate index warning | Johannes Berg | 2008-11-21 |
| * | b43legacy: implement short slot and basic rate handling | Johannes Berg | 2008-11-21 |
| * | ipw2200: make association only if SSID is known. | Alexey Fisher | 2008-11-21 |
| * | ath9k: enable RXing of beacons on STA/IBSS | Luis R. Rodriguez | 2008-11-21 |
| * | ath5k: allow APs to receive beacons | Luis R. Rodriguez | 2008-11-21 |
| * | ath5k: Fix IMR init | Nick Kossifidis | 2008-11-21 |
| * | ath9k : Display MAC/BB and RF version at startup (v2) | Benoit PAPILLAULT | 2008-11-21 |
| * | mac80211: fix BUILD_BUG_ON() caused by misalignment on arm | Felix Fietkau | 2008-11-21 |
| * | ath5k: ignore the return value of ath5k_hw_noise_floor_calibration | Felix Fietkau | 2008-11-21 |
| * | rt2x00: Fix BUG_ON() with antenna handling | Ivo van Doorn | 2008-11-21 |
| * | rt2x00: Block set_key() during suspend/shutdown | Ivo van Doorn | 2008-11-21 |
| * | rt2x00: Fix LED state handling | Ivo van Doorn | 2008-11-21 |
| * | rt2x00: Remove RATE_BASIC flag | Ivo van Doorn | 2008-11-21 |
| * | Move all rtl818x files to a common directory. | Larry Finger | 2008-11-21 |
| * | mac80211_hwsim: enable Mesh Point operation | Andrey Yurovsky | 2008-11-21 |
| * | mac80211: disable BSSID filtering for mesh interfaces | Andrey Yurovsky | 2008-11-21 |
| * | ssb: struct device - replace bus_id with dev_name(), dev_set_name() | Kay Sievers | 2008-11-21 |
| * | libertas: Fine grained configuration of wake-on-lan. | Anna Neal | 2008-11-21 |
| * | ipw2100, ipw2200: select LIB80211 | John W. Linville | 2008-11-21 |
| * | netdevice zd1201: Convert directly reference of netdev->priv to netdev_priv() | John W. Linville | 2008-11-21 |
* | | e1000e: check return code from NVM accesses and fix bank detection | Bruce Allan | 2008-11-21 |
* | | e1000e: fix incorrect link status when switch module pulled | Bruce Allan | 2008-11-21 |
* | | e1000e: store EEPROM version number to prevent unnecessary NVM reads | Bruce Allan | 2008-11-21 |
* | | e1000e: cosmetic newline in debug message | Bruce Allan | 2008-11-21 |
* | | e1000e: sync change flow control variables with ixgbe | Bruce Allan | 2008-11-21 |
* | | e1000e: link up/down messages must follow a specific format | Bruce Allan | 2008-11-21 |
* | | e1000e: ESB2 config after link up | Bruce Allan | 2008-11-21 |
* | | e1000e: check return of pci_save_state | Bruce Allan | 2008-11-21 |
* | | e1000e: update comments listing supported parts for each MAC family | Bruce Allan | 2008-11-21 |
* | | e1000e: 82571 check for link fix on 82571 serdes | Bruce Allan | 2008-11-21 |
* | | e1000e: commit speed/duplex changes for m88 PHY | Bruce Allan | 2008-11-21 |
* | | e1000e: disable correctable errors for quad ports while going to D3 | Alexander Duyck | 2008-11-21 |
* | | inet_diag: Missed conversion after changing inet ehash lockl to spinlocks. | David S. Miller | 2008-11-21 |