aboutsummaryrefslogtreecommitdiffstats
Commit message (Expand)AuthorAge
* [ARM] pxa: Add zylonite MFP wakeup configurationsRussell King2008-01-26
* [ARM] pxa: program MFPs for low power mode when suspendingRussell King2008-01-26
* [ARM] pxa: make MFP configuration processor independenteric miao2008-01-26
* [ARM] pxa: remove un-used pxa3xx_mfp_set_xxx() functionseric miao2008-01-26
* [ARM] pxa: introduce a new file mfp-pxa3xx.h for common pin configurationseric miao2008-01-26
* [ARM] pxa: omit PXA25x or PXA27x standby/sleep code as appropriateRussell King2008-01-26
* [ARM] pxa: clean up pxa{27x,25x}_init_pm() to empty if CONFIG_PM not definederic miao2008-01-26
* [ARM] pxa: move memory controller registers into pxa2xx-regs.hRussell King2008-01-26
* [ARM] pxa: increase size of memory mappingRussell King2008-01-26
* [ARM] pxa: move pxa27x_device_ohci out of pxa27x.c for use with pxa3xxeric miao2008-01-26
* [ARM] USB: update to allow pxa27x ohci driver to support pxa3xxeric miao2008-01-26
* [ARM] USB: update pxa27x ohci driver to use clk supporteric miao2008-01-26
* [ARM] pxa: make OHCI register definitions available to both pxa27x and pxa3xxeric miao2008-01-26
* [ARM] pxa: add clk of CKEN_USBHOST for pxa3xxeric miao2008-01-26
* [ARM] pxa: ensure SSP TX FIFO is empty instead of not full for pxa3xxeric miao2008-01-26
* [ARM] pxa: mmc: add 3rd host controller support for pxa310Bridge Wu2008-01-26
* [ARM] pxa: mmc: add 2nd host controller support for pxa3xxBridge Wu2008-01-26
* [ARM] pxa: mmc: add 1st host controller support for pxa3xxBridge Wu2008-01-26
* [ARM] pxa: create arch/arm/mach-pxa/device.c for all on-chip deviceseric miao2008-01-26
* [ARM] 4718/1: Fix redefinition warnings in PXA uncompressor codePhilipp Zabel2008-01-26
* [ARM] 4711/1: pxa: mmc: move DMA specific code to platform layerBridge Wu2008-01-26
* [ARM] 4709/1: pxa: mmc: add 26MHz support for pxa3[0|1]0 mmc controllerBridge Wu2008-01-26
* [ARM] pxa: add cpufreq supportRussell King2008-01-26
* [ARM] pxa: initialise SSP earlierRussell King2008-01-26
* [ARM] pxa: only register "cpld_irq" for the correct platformRussell King2008-01-26
* [ARM] pxa: make pxa2xx_spi driver use ssp_request()/ssp_free()eric miao2008-01-26
* [ARM] pxa: use __raw_writel()/__raw_readl() for ssp_xxxx()eric miao2008-01-26
* [ARM] pxa: move SSP register definitions from pxa-regs.h to regs-ssp.heric miao2008-01-26
* [ARM] pxa: define "struct ssp_device" and add ssp_request()/ssp_free()eric miao2008-01-26
* [ARM] pxa: add ssp devices and clk support for pxa25x/pxa27x/pxa3xxeric miao2008-01-26
* [ARM] pxa: define SSP platform devices for pxa2xx/pxa3xxeric miao2008-01-26
* [ARM] 4663/1: Only putc uncompressor output into FFUART if it was enabled by ...Philipp Zabel2008-01-26
* [ARM] pxa/sa1100: replace wakeup supportRussell King2008-01-26
* [ARM] pxa: Don't wind OSCR backwards over suspend/resumeRussell King2008-01-26
* [ARM] pxa: remove periodic mode emulation supportRussell King2008-01-26
* [ARM] pxa: mainstone: update backlight to use the backlight infrastructureRussell King2008-01-26
* [ARM] pxa: avoid always registering MMC, I2C, IrDA and framebuffer devicesRussell King2008-01-26
* [ARM] Update mach-typesRussell King2008-01-26
* Merge git://git.kernel.org/pub/scm/linux/kernel/git/jejb/scsi-misc-2.6Linus Torvalds2008-01-25
|\
| * [SCSI] usbstorage: use last_sector_bug flag universallyHans de Goede2008-01-25
| * [SCSI] libsas: abstract STP task status into a functionJames Bottomley2008-01-25
| * [SCSI] ultrastor: clean up inline asm warningsFrederik Deweerdt2008-01-25
| * [SCSI] aic7xxx: fix firmware buildVegard Nossum2008-01-25
| * [SCSI] aacraid: fib context lock for management ioctlsSalyzyn, Mark2008-01-25
| * [SCSI] ch: remove forward declarationsFUJITA Tomonori2008-01-25
| * [SCSI] ch: fix device minor number management bugFUJITA Tomonori2008-01-25
| * [SCSI] ch: handle class_device_create failure properlyFUJITA Tomonori2008-01-23
| * [SCSI] NCR5380: fix section mismatchRandy Dunlap2008-01-23
| * [SCSI] sg: fix /proc/scsi/sg/devices when no SCSI devicesTony Battersby2008-01-23
| * [SCSI] IB/iSER: add logical unit reset supportErez Zilber2008-01-23