1 files changed, 18 insertions, 8 deletions

diff --git a/drivers/ide/Kconfig b/drivers/ide/Kconfig
index 6eaece96524e..e445fe6e4ba9 100644
--- a/drivers/ide/Kconfig
+++ b/drivers/ide/Kconfig
@@ -152,9 +152,22 @@ config BLK_DEV_IDEDISK
           If unsure, say Y.
 
 config IDEDISK_MULTI_MODE
-        bool "Use multi-mode by default"
-        help
-          If you get this error, try to say Y here:
+        bool "Use multiple sector mode for Programmed Input/Output by default"
+        help
+          This setting is irrelevant for most IDE disks, with direct memory
+          access, to which multiple sector mode does not apply. Multiple sector
+          mode is a feature of most modern IDE hard drives, permitting the
+          transfer of multiple sectors per Programmed Input/Output interrupt,
+          rather than the usual one sector per interrupt. When this feature is
+          enabled, it can reduce operating system overhead for disk Programmed
+          Input/Output. On some systems, it also can increase the data
+          throughput of Programmed Input/Output. Some drives, however, seemed
+          to run slower with multiple sector mode enabled. Some drives claimed
+          to support multiple sector mode, but lost data at some settings.
+          Under rare circumstances, such failures could result in massive
+          filesystem corruption.
+
+          If you get the following error, try to say Y here:
 
           hda: set_multmode: status=0x51 { DriveReady SeekComplete Error }
           hda: set_multmode: error=0x04 { DriveStatusError }
@@ -190,10 +203,6 @@ config BLK_DEV_IDECD
           CD-ROM drive, you can say N to all other CD-ROM options, but be sure
           to say Y or M to "ISO 9660 CD-ROM file system support".
 
-          Note that older versions of LILO (LInux LOader) cannot properly deal
-          with IDE/ATAPI CD-ROMs, so install LILO 16 or higher, available from
-          <http://lilo.go.dyndns.org/>.
-
           To compile this driver as a module, choose M here: the
           module will be called ide-cd.
 
@@ -380,9 +389,10 @@ config IDEPCI_SHARE_IRQ
 config IDEPCI_PCIBUS_ORDER
         def_bool BLK_DEV_IDE=y && BLK_DEV_IDEPCI
 
+# TODO: split it on per host driver config options (or module parameters)
 config BLK_DEV_OFFBOARD
         bool "Boot off-board chipsets first support"
-        depends on BLK_DEV_IDEPCI
+        depends on BLK_DEV_IDEPCI && (BLK_DEV_AEC62XX || BLK_DEV_GENERIC || BLK_DEV_HPT34X || BLK_DEV_HPT366 || BLK_DEV_PDC202XX_NEW || BLK_DEV_PDC202XX_OLD || BLK_DEV_TC86C001)
         help
           Normally, IDE controllers built into the motherboard (on-board
           controllers) are assigned to ide0 and ide1 while those on add-in PCI