1 files changed, 3 insertions, 3 deletions

diff --git a/arch/powerpc/oprofile/op_model_cell.c b/arch/powerpc/oprofile/op_model_cell.c
index ae06c6236d9c..2c9e52267292 100644
--- a/arch/powerpc/oprofile/op_model_cell.c
+++ b/arch/powerpc/oprofile/op_model_cell.c
@@ -248,7 +248,7 @@ static int pm_rtas_activate_signals(u32 node, u32 count)
          * There is no debug setup required for the cycles event.
          * Note that only events in the same group can be used.
          * Otherwise, there will be conflicts in correctly routing
-         * the signals on the debug bus.  It is the responsiblity
+         * the signals on the debug bus.  It is the responsibility
          * of the OProfile user tool to check the events are in
          * the same group.
          */
@@ -1594,7 +1594,7 @@ static void cell_handle_interrupt_spu(struct pt_regs *regs,
                  * to a latch.  The new values (interrupt setting bits, reset
                  * counter value etc.) are not copied to the actual registers
                  * until the performance monitor is enabled.  In order to get
-                 * this to work as desired, the permormance monitor needs to
+                 * this to work as desired, the performance monitor needs to
                  * be disabled while writing to the latches.  This is a
                  * HW design issue.
                  */
@@ -1668,7 +1668,7 @@ static void cell_handle_interrupt_ppu(struct pt_regs *regs,
                  * to a latch.  The new values (interrupt setting bits, reset
                  * counter value etc.) are not copied to the actual registers
                  * until the performance monitor is enabled.  In order to get
-                 * this to work as desired, the permormance monitor needs to
+                 * this to work as desired, the performance monitor needs to
                  * be disabled while writing to the latches.  This is a
                  * HW design issue.
                  */