1 files changed, 106 insertions, 87 deletions

diff --git a/arch/mips/kernel/smp-mt.c b/arch/mips/kernel/smp-mt.c
index 2ab0b7eeaa7e..89e6f6aa5166 100644
--- a/arch/mips/kernel/smp-mt.c
+++ b/arch/mips/kernel/smp-mt.c
@@ -215,72 +215,67 @@ static void __init smp_tc_init(unsigned int tc, unsigned int mvpconf0)
         write_tc_c0_tchalt(TCHALT_H);
 }
 
-/*
- * Common setup before any secondaries are started
- * Make sure all CPU's are in a sensible state before we boot any of the
- * secondarys
- */
-void __init plat_smp_setup(void)
+static void vsmp_send_ipi_single(int cpu, unsigned int action)
 {
-        unsigned int mvpconf0, ntc, tc, ncpu = 0;
-        unsigned int nvpe;
+        int i;
+        unsigned long flags;
+        int vpflags;
 
-#ifdef CONFIG_MIPS_MT_FPAFF
-        /* If we have an FPU, enroll ourselves in the FPU-full mask */
-        if (cpu_has_fpu)
-                cpu_set(0, mt_fpu_cpumask);
-#endif /* CONFIG_MIPS_MT_FPAFF */
-        if (!cpu_has_mipsmt)
-                return;
+        local_irq_save(flags);
 
-        /* disable MT so we can configure */
-        dvpe();
-        dmt();
+        vpflags = dvpe();       /* cant access the other CPU's registers whilst MVPE enabled */
 
-        /* Put MVPE's into 'configuration state' */
-        set_c0_mvpcontrol(MVPCONTROL_VPC);
+        switch (action) {
+        case SMP_CALL_FUNCTION:
+                i = C_SW1;
+                break;
 
-        mvpconf0 = read_c0_mvpconf0();
-        ntc = (mvpconf0 & MVPCONF0_PTC) >> MVPCONF0_PTC_SHIFT;
+        case SMP_RESCHEDULE_YOURSELF:
+        default:
+                i = C_SW0;
+                break;
+        }
 
-        nvpe = ((mvpconf0 & MVPCONF0_PVPE) >> MVPCONF0_PVPE_SHIFT) + 1;
-        smp_num_siblings = nvpe;
+        /* 1:1 mapping of vpe and tc... */
+        settc(cpu);
+        write_vpe_c0_cause(read_vpe_c0_cause() | i);
+        evpe(vpflags);
 
-        /* we'll always have more TC's than VPE's, so loop setting everything
-           to a sensible state */
-        for (tc = 0; tc <= ntc; tc++) {
-                settc(tc);
+        local_irq_restore(flags);
+}
 
-                smp_tc_init(tc, mvpconf0);
-                ncpu = smp_vpe_init(tc, mvpconf0, ncpu);
-        }
+static void vsmp_send_ipi_mask(cpumask_t mask, unsigned int action)
+{
+        unsigned int i;
 
-        /* Release config state */
-        clear_c0_mvpcontrol(MVPCONTROL_VPC);
+        for_each_cpu_mask(i, mask)
+                vsmp_send_ipi_single(i, action);
+}
 
-        /* We'll wait until starting the secondaries before starting MVPE */
+static void __cpuinit vsmp_init_secondary(void)
+{
+        /* Enable per-cpu interrupts */
 
-        printk(KERN_INFO "Detected %i available secondary CPU(s)\n", ncpu);
+        /* This is Malta specific: IPI,performance and timer inetrrupts */
+        write_c0_status((read_c0_status() & ~ST0_IM ) |
+                        (STATUSF_IP0 | STATUSF_IP1 | STATUSF_IP6 | STATUSF_IP7));
 }
 
-void __init plat_prepare_cpus(unsigned int max_cpus)
+static void __cpuinit vsmp_smp_finish(void)
 {
-        mips_mt_set_cpuoptions();
-
-        /* set up ipi interrupts */
-        if (cpu_has_vint) {
-                set_vi_handler(MIPS_CPU_IPI_RESCHED_IRQ, ipi_resched_dispatch);
-                set_vi_handler(MIPS_CPU_IPI_CALL_IRQ, ipi_call_dispatch);
-        }
+        write_c0_compare(read_c0_count() + (8* mips_hpt_frequency/HZ));
 
-        cpu_ipi_resched_irq = MIPS_CPU_IRQ_BASE + MIPS_CPU_IPI_RESCHED_IRQ;
-        cpu_ipi_call_irq = MIPS_CPU_IRQ_BASE + MIPS_CPU_IPI_CALL_IRQ;
+#ifdef CONFIG_MIPS_MT_FPAFF
+        /* If we have an FPU, enroll ourselves in the FPU-full mask */
+        if (cpu_has_fpu)
+                cpu_set(smp_processor_id(), mt_fpu_cpumask);
+#endif /* CONFIG_MIPS_MT_FPAFF */
 
-        setup_irq(cpu_ipi_resched_irq, &irq_resched);
-        setup_irq(cpu_ipi_call_irq, &irq_call);
+        local_irq_enable();
+}
 
-        set_irq_handler(cpu_ipi_resched_irq, handle_percpu_irq);
-        set_irq_handler(cpu_ipi_call_irq, handle_percpu_irq);
+static void vsmp_cpus_done(void)
+{
 }
 
 /*
@@ -291,7 +286,7 @@ void __init plat_prepare_cpus(unsigned int max_cpus)
  * (unsigned long)idle->thread_info the gp
  * assumes a 1:1 mapping of TC => VPE
  */
-void __cpuinit prom_boot_secondary(int cpu, struct task_struct *idle)
+static void __cpuinit vsmp_boot_secondary(int cpu, struct task_struct *idle)
 {
         struct thread_info *gp = task_thread_info(idle);
         dvpe();
@@ -325,57 +320,81 @@ void __cpuinit prom_boot_secondary(int cpu, struct task_struct *idle)
         evpe(EVPE_ENABLE);
 }
 
-void __cpuinit prom_init_secondary(void)
-{
-        /* Enable per-cpu interrupts */
-
-        /* This is Malta specific: IPI,performance and timer inetrrupts */
-        write_c0_status((read_c0_status() & ~ST0_IM ) |
-                        (STATUSF_IP0 | STATUSF_IP1 | STATUSF_IP6 | STATUSF_IP7));
-}
-
-void __cpuinit prom_smp_finish(void)
+/*
+ * Common setup before any secondaries are started
+ * Make sure all CPU's are in a sensible state before we boot any of the
+ * secondarys
+ */
+static void __init vsmp_smp_setup(void)
 {
-        write_c0_compare(read_c0_count() + (8* mips_hpt_frequency/HZ));
+        unsigned int mvpconf0, ntc, tc, ncpu = 0;
+        unsigned int nvpe;
 
 #ifdef CONFIG_MIPS_MT_FPAFF
         /* If we have an FPU, enroll ourselves in the FPU-full mask */
         if (cpu_has_fpu)
-                cpu_set(smp_processor_id(), mt_fpu_cpumask);
+                cpu_set(0, mt_fpu_cpumask);
 #endif /* CONFIG_MIPS_MT_FPAFF */
+        if (!cpu_has_mipsmt)
+                return;
 
-        local_irq_enable();
-}
+        /* disable MT so we can configure */
+        dvpe();
+        dmt();
 
-void prom_cpus_done(void)
-{
-}
+        /* Put MVPE's into 'configuration state' */
+        set_c0_mvpcontrol(MVPCONTROL_VPC);
 
-void core_send_ipi(int cpu, unsigned int action)
-{
-        int i;
-        unsigned long flags;
-        int vpflags;
+        mvpconf0 = read_c0_mvpconf0();
+        ntc = (mvpconf0 & MVPCONF0_PTC) >> MVPCONF0_PTC_SHIFT;
 
-        local_irq_save(flags);
+        nvpe = ((mvpconf0 & MVPCONF0_PVPE) >> MVPCONF0_PVPE_SHIFT) + 1;
+        smp_num_siblings = nvpe;
 
-        vpflags = dvpe();       /* cant access the other CPU's registers whilst MVPE enabled */
+        /* we'll always have more TC's than VPE's, so loop setting everything
+           to a sensible state */
+        for (tc = 0; tc <= ntc; tc++) {
+                settc(tc);
 
-        switch (action) {
-        case SMP_CALL_FUNCTION:
-                i = C_SW1;
-                break;
+                smp_tc_init(tc, mvpconf0);
+                ncpu = smp_vpe_init(tc, mvpconf0, ncpu);
+        }
 
-        case SMP_RESCHEDULE_YOURSELF:
-        default:
-                i = C_SW0;
-                break;
+        /* Release config state */
+        clear_c0_mvpcontrol(MVPCONTROL_VPC);
+
+        /* We'll wait until starting the secondaries before starting MVPE */
+
+        printk(KERN_INFO "Detected %i available secondary CPU(s)\n", ncpu);
+}
+
+static void __init vsmp_prepare_cpus(unsigned int max_cpus)
+{
+        mips_mt_set_cpuoptions();
+
+        /* set up ipi interrupts */
+        if (cpu_has_vint) {
+                set_vi_handler(MIPS_CPU_IPI_RESCHED_IRQ, ipi_resched_dispatch);
+                set_vi_handler(MIPS_CPU_IPI_CALL_IRQ, ipi_call_dispatch);
         }
 
-        /* 1:1 mapping of vpe and tc... */
-        settc(cpu);
-        write_vpe_c0_cause(read_vpe_c0_cause() | i);
-        evpe(vpflags);
+        cpu_ipi_resched_irq = MIPS_CPU_IRQ_BASE + MIPS_CPU_IPI_RESCHED_IRQ;
+        cpu_ipi_call_irq = MIPS_CPU_IRQ_BASE + MIPS_CPU_IPI_CALL_IRQ;
 
-        local_irq_restore(flags);
+        setup_irq(cpu_ipi_resched_irq, &irq_resched);
+        setup_irq(cpu_ipi_call_irq, &irq_call);
+
+        set_irq_handler(cpu_ipi_resched_irq, handle_percpu_irq);
+        set_irq_handler(cpu_ipi_call_irq, handle_percpu_irq);
 }
+
+struct plat_smp_ops vsmp_smp_ops = {
+        .send_ipi_single        = vsmp_send_ipi_single,
+        .send_ipi_mask          = vsmp_send_ipi_mask,
+        .init_secondary         = vsmp_init_secondary,
+        .smp_finish             = vsmp_smp_finish,
+        .cpus_done              = vsmp_cpus_done,
+        .boot_secondary         = vsmp_boot_secondary,
+        .smp_setup              = vsmp_smp_setup,
+        .prepare_cpus           = vsmp_prepare_cpus,
+};