1 files changed, 0 insertions, 39 deletions

diff --git a/arch/cris/arch-v10/drivers/Kconfig b/arch/cris/arch-v10/drivers/Kconfig
index faf8b4d3ca01..e3c0f2928149 100644
--- a/arch/cris/arch-v10/drivers/Kconfig
+++ b/arch/cris/arch-v10/drivers/Kconfig
@@ -542,45 +542,6 @@ config ETRAX_RS485_DISABLE_RECEIVER
           loopback.  Not all products are able to do this in software only.
           Axis 2400/2401 must disable receiver.
 
-config ETRAX_IDE
-        bool "ATA/IDE support"
-        select IDE
-        select BLK_DEV_IDE
-        select BLK_DEV_IDEDISK
-        select BLK_DEV_IDECD
-        select BLK_DEV_IDEDMA
-        select IDE_GENERIC
-        help
-          Enable this to get support for ATA/IDE.
-          You can't use parallel ports or SCSI ports
-          at the same time.
-
-
-config ETRAX_IDE_DELAY
-        int "Delay for drives to regain consciousness"
-        depends on ETRAX_IDE
-        default 15
-        help
-          Number of seconds to wait for IDE drives to spin up after an IDE
-          reset.
-choice
-        prompt "IDE reset pin"
-        depends on ETRAX_IDE
-        default ETRAX_IDE_PB7_RESET
-
-config ETRAX_IDE_PB7_RESET
-        bool "Port_PB_Bit_7"
-        help
-          IDE reset on pin 7 on port B
-
-config ETRAX_IDE_G27_RESET
-        bool "Port_G_Bit_27"
-        help
-          IDE reset on pin 27 on port G
-
-endchoice
-
-
 config ETRAX_USB_HOST
         bool "USB host"
         select USB