1 files changed, 5 insertions, 8 deletions

diff --git a/arch/arm/mach-at91/board-cap9adk.c b/arch/arm/mach-at91/board-cap9adk.c
index e7274440ead9..1904fdf87613 100644
--- a/arch/arm/mach-at91/board-cap9adk.c
+++ b/arch/arm/mach-at91/board-cap9adk.c
@@ -44,12 +44,13 @@
 #include <mach/gpio.h>
 #include <mach/at91cap9_matrix.h>
 #include <mach/at91sam9_smc.h>
+#include <mach/system_rev.h>
 
 #include "sam9_smc.h"
 #include "generic.h"
 
 
-static void __init cap9adk_map_io(void)
+static void __init cap9adk_init_early(void)
 {
         /* Initialize processor: 12 MHz crystal */
         at91cap9_initialize(12000000);
@@ -187,11 +188,6 @@ static struct atmel_nand_data __initdata cap9adk_nand_data = {
 //      .rdy_pin        = ... not connected
         .enable_pin     = AT91_PIN_PD15,
         .partition_info = nand_partitions,
-#if defined(CONFIG_MTD_NAND_ATMEL_BUSWIDTH_16)
-        .bus_width_16   = 1,
-#else
-        .bus_width_16   = 0,
-#endif
 };
 
 static struct sam9_smc_config __initdata cap9adk_nand_smc_config = {
@@ -219,6 +215,7 @@ static void __init cap9adk_add_device_nand(void)
         csa = at91_sys_read(AT91_MATRIX_EBICSA);
         at91_sys_write(AT91_MATRIX_EBICSA, csa | AT91_MATRIX_EBI_VDDIOMSEL_3_3V);
 
+        cap9adk_nand_data.bus_width_16 = !board_have_nand_8bit();
         /* setup bus-width (8 or 16) */
         if (cap9adk_nand_data.bus_width_16)
                 cap9adk_nand_smc_config.mode |= AT91_SMC_DBW_16;
@@ -399,9 +396,9 @@ static void __init cap9adk_board_init(void)
 
 MACHINE_START(AT91CAP9ADK, "Atmel AT91CAP9A-DK")
         /* Maintainer: Stelian Pop <stelian.pop@leadtechdesign.com> */
-        .boot_params    = AT91_SDRAM_BASE + 0x100,
         .timer          = &at91sam926x_timer,
-        .map_io         = cap9adk_map_io,
+        .map_io         = at91cap9_map_io,
+        .init_early     = cap9adk_init_early,
         .init_irq       = cap9adk_init_irq,
         .init_machine   = cap9adk_board_init,
 MACHINE_END