2 files changed, 13 insertions, 4 deletions

diff --git a/Documentation/kernel-parameters.txt b/Documentation/kernel-parameters.txt
index 736d45602886..e7848a0d99eb 100644
--- a/Documentation/kernel-parameters.txt
+++ b/Documentation/kernel-parameters.txt
@@ -199,6 +199,10 @@ and is between 256 and 4096 characters. It is defined in the file
                         acpi_display_output=video
                         See above.
 
+        acpi_early_pdc_eval     [HW,ACPI] Evaluate processor _PDC methods
+                                early. Needed on some platforms to properly
+                                initialize the EC.
+
         acpi_irq_balance [HW,ACPI]
                         ACPI will balance active IRQs
                         default in APIC mode
@@ -311,6 +315,11 @@ and is between 256 and 4096 characters. It is defined in the file
         aic79xx=        [HW,SCSI]
                         See Documentation/scsi/aic79xx.txt.
 
+        alignment=      [KNL,ARM]
+                        Allow the default userspace alignment fault handler
+                        behaviour to be specified.  Bit 0 enables warnings,
+                        bit 1 enables fixups, and bit 2 sends a segfault.
+
         amd_iommu=      [HW,X86-84]
                         Pass parameters to the AMD IOMMU driver in the system.
                         Possible values are:
diff --git a/Documentation/networking/ip-sysctl.txt b/Documentation/networking/ip-sysctl.txt
index 006b39dec87d..e87f3cdc8a6a 100644
--- a/Documentation/networking/ip-sysctl.txt
+++ b/Documentation/networking/ip-sysctl.txt
@@ -1074,10 +1074,10 @@ regen_max_retry - INTEGER
         Default: 5
 
 max_addresses - INTEGER
-        Number of maximum addresses per interface.  0 disables limitation.
-        It is recommended not set too large value (or 0) because it would
-        be too easy way to crash kernel to allow to create too much of
-        autoconfigured addresses.
+        Maximum number of autoconfigured addresses per interface.  Setting
+        to zero disables the limitation.  It is not recommended to set this
+        value too large (or to zero) because it would be an easy way to
+        crash the kernel by allowing too many addresses to be created.
         Default: 16
 
 disable_ipv6 - BOOLEAN