1 files changed, 1 insertions, 32 deletions

diff --git a/Documentation/ide/ide.txt b/Documentation/ide/ide.txt
index ae4f4f43c25c..18c02df2f78f 100644
--- a/Documentation/ide/ide.txt
+++ b/Documentation/ide/ide.txt
@@ -71,29 +71,6 @@ This driver automatically probes for most IDE interfaces (including all PCI
 ones), for the drives/geometries attached to those interfaces, and for the IRQ
 lines being used by the interfaces (normally 14, 15 for ide0/ide1).
 
-For special cases, interfaces may be specified using kernel "command line"
-options.  For example,
-
-        ide3=0x168,0x36e,10     /* ioports 0x168-0x16f,0x36e, irq 10 */
-
-Normally the irq number need not be specified, as ide.c will probe for it:
-
-        ide3=0x168,0x36e        /* ioports 0x168-0x16f,0x36e */
-
-The standard port, and irq values are these:
-
-        ide0=0x1f0,0x3f6,14
-        ide1=0x170,0x376,15
-        ide2=0x1e8,0x3ee,11
-        ide3=0x168,0x36e,10
-
-Note that the first parameter reserves 8 contiguous ioports, whereas the
-second value denotes a single ioport. If in doubt, do a 'cat /proc/ioports'.
-
-In all probability the device uses these ports and IRQs if it is attached
-to the appropriate ide channel.  Pass the parameter for the correct ide
-channel to the kernel, as explained above.
-
 Any number of interfaces may share a single IRQ if necessary, at a slight
 performance penalty, whether on separate cards or a single VLB card.
 The IDE driver automatically detects and handles this.  However, this may
@@ -199,7 +176,7 @@ When ide.c is used as a module, you can pass command line parameters to the
 driver using the "options=" keyword to insmod, while replacing any ',' with
 ';'.  For example:
 
-        insmod ide.o options="ide0=serialize ide1=serialize ide2=0x1e8;0x3ee;11"
+        insmod ide.o options="hda=nodma hdb=nodma"
 
 
 ================================================================================
@@ -240,14 +217,6 @@ Summary of ide driver parameters for kernel command line
                           As for VLB, it is safest to not specify it.
                           Bigger values are safer than smaller ones.
 
- "idex=base"            : probe for an interface at the addr specified,
-                          where "base" is usually 0x1f0 or 0x170
-                          and "ctl" is assumed to be "base"+0x206
-
- "idex=base,ctl"        : specify both base and ctl
-
- "idex=base,ctl,irq"    : specify base, ctl, and irq number
-
  "idex=serialize"       : do not overlap operations on idex. Please note
                           that you will have to specify this option for
                           both the respective primary and secondary channel