1 files changed, 30 insertions, 0 deletions

diff --git a/Documentation/sound/alsa/ALSA-Configuration.txt b/Documentation/sound/alsa/ALSA-Configuration.txt
index 4252697a95d6..1c8eb4518ce0 100644
--- a/Documentation/sound/alsa/ALSA-Configuration.txt
+++ b/Documentation/sound/alsa/ALSA-Configuration.txt
@@ -60,6 +60,12 @@ Prior to version 0.9.0rc4 options had a 'snd_' prefix. This was removed.
     slots       - Reserve the slot index for the given driver.
                   This option takes multiple strings.           
                   See "Module Autoloading Support" section for details.
+    debug       - Specifies the debug message level
+                  (0 = disable debug prints, 1 = normal debug messages,
+                   2 = verbose debug messages)
+                  This option appears only when CONFIG_SND_DEBUG=y.
+                  This option can be dynamically changed via sysfs
+                  /sys/modules/snd/parameters/debug file.
   
   Module snd-pcm-oss
   ------------------
@@ -513,6 +519,26 @@ Prior to version 0.9.0rc4 options had a 'snd_' prefix. This was removed.
     or input, but you may use this module for any application which
     requires a sound card (like RealPlayer).
 
+    pcm_devs       - Number of PCM devices assigned to each card
+                     (default = 1, up to 4)
+    pcm_substreams - Number of PCM substreams assigned to each PCM
+                     (default = 8, up to 16)
+    hrtimer        - Use hrtimer (=1, default) or system timer (=0)
+    fake_buffer    - Fake buffer allocations (default = 1)
+
+    When multiple PCM devices are created, snd-dummy gives different
+    behavior to each PCM device:
+      0 = interleaved with mmap support
+      1 = non-interleaved with mmap support
+      2 = interleaved without mmap 
+      3 = non-interleaved without mmap
+
+    As default, snd-dummy drivers doesn't allocate the real buffers
+    but either ignores read/write or mmap a single dummy page to all
+    buffer pages, in order to save the resouces.  If your apps need
+    the read/ written buffer data to be consistent, pass fake_buffer=0
+    option.
+
     The power-management is supported.
 
   Module snd-echo3g
@@ -768,6 +794,10 @@ Prior to version 0.9.0rc4 options had a 'snd_' prefix. This was removed.
     bdl_pos_adj - Specifies the DMA IRQ timing delay in samples.
                 Passing -1 will make the driver to choose the appropriate
                 value based on the controller chip.
+    patch       - Specifies the early "patch" files to modify the HD-audio
+                setup before initializing the codecs.  This option is
+                available only when CONFIG_SND_HDA_PATCH_LOADER=y is set.
+                See HD-Audio.txt for details.
     
     [Single (global) options]
     single_cmd  - Use single immediate commands to communicate with