1 files changed, 3 insertions, 18 deletions

diff --git a/Documentation/ide/ide.txt b/Documentation/ide/ide.txt
index e3b3425328b6..818676aad45a 100644
--- a/Documentation/ide/ide.txt
+++ b/Documentation/ide/ide.txt
@@ -105,7 +105,7 @@ Drives are normally found by auto-probing and/or examining the CMOS/BIOS data.
 For really weird situations, the apparent (fdisk) geometry can also be specified
 on the kernel "command line" using LILO.  The format of such lines is:
 
-        hdx=cyls,heads,sects,wpcom,irq
+        hdx=cyls,heads,sects
 or      hdx=cdrom
 
 where hdx can be any of hda through hdh, Three values are required
@@ -214,9 +214,9 @@ driver using the "options=" keyword to insmod, while replacing any ',' with
 Summary of ide driver parameters for kernel command line
 --------------------------------------------------------
 
- "hdx="  is recognized for all "x" from "a" to "h", such as "hdc".
+ "hdx="  is recognized for all "x" from "a" to "u", such as "hdc".
 
- "idex=" is recognized for all "x" from "0" to "3", such as "ide1".
+ "idex=" is recognized for all "x" from "0" to "9", such as "ide1".
 
  "hdx=noprobe"          : drive may be present, but do not probe for it
 
@@ -228,13 +228,6 @@ Summary of ide driver parameters for kernel command line
 
  "hdx=cyl,head,sect"    : disk drive is present, with specified geometry
 
- "hdx=remap"            : remap access of sector 0 to sector 1 (for EZDrive)
-
- "hdx=remap63"          : remap the drive: add 63 to all sector numbers
-                          (for DM OnTrack)
-
- "idex=noautotune"      : driver will NOT attempt to tune interface speed
-
  "hdx=autotune"         : driver will attempt to tune interface speed
                           to the fastest PIO mode supported,
                           if possible for this drive only.
@@ -244,10 +237,6 @@ Summary of ide driver parameters for kernel command line
 
  "hdx=nodma"            : disallow DMA
 
- "hdx=scsi"             : the return of the ide-scsi flag, this is useful for
-                          allowing ide-floppy, ide-tape, and ide-cdrom|writers
-                          to use ide-scsi emulation on a device specific option.
-
  "idebus=xx"            : inform IDE driver of VESA/PCI bus speed in MHz,
                           where "xx" is between 20 and 66 inclusive,
                           used when tuning chipset PIO modes.
@@ -282,10 +271,6 @@ Summary of ide driver parameters for kernel command line
 
  "ide=reverse"          : formerly called to pci sub-system, but now local.
 
-The following are valid ONLY on ide0, which usually corresponds
-to the first ATA interface found on the particular host, and the defaults for
-the base,ctl ports must not be altered.
-
  "ide=doubler"          : probe/support IDE doublers on Amiga
 
 There may be more options than shown -- use the source, Luke!