1 files changed, 5 insertions, 5 deletions

diff --git a/Documentation/hwmon/abituguru-datasheet b/Documentation/hwmon/abituguru-datasheet
index aef5a9b36846..d9251efdcec7 100644
--- a/Documentation/hwmon/abituguru-datasheet
+++ b/Documentation/hwmon/abituguru-datasheet
@@ -74,7 +74,7 @@ a sensor.
 Notice that some banks have both a read and a write address this is how the
 uGuru determines if a read from or a write to the bank is taking place, thus
 when reading you should always use the read address and when writing the
-write address. The write address is always one (1) more then the read address.
+write address. The write address is always one (1) more than the read address.
 
 
 uGuru ready
@@ -121,7 +121,7 @@ Once all bytes have been read data will hold 0x09, but there is no reason to
 test for this. Notice that the number of bytes is bank address dependent see
 above and below.
 
-After completing a successfull read it is advised to put the uGuru back in
+After completing a successful read it is advised to put the uGuru back in
 ready mode, so that it is ready for the next read / write cycle. This way
 if your program / driver is unloaded and later loaded again the detection
 algorithm described above will still work.
@@ -141,7 +141,7 @@ don't ask why this is the way it is.
 
 Once DATA holds 0x01 read CMD it should hold 0xAC now.
 
-After completing a successfull write it is advised to put the uGuru back in
+After completing a successful write it is advised to put the uGuru back in
 ready mode, so that it is ready for the next read / write cycle. This way
 if your program / driver is unloaded and later loaded again the detection
 algorithm described above will still work.
@@ -224,7 +224,7 @@ Bit 3: Beep if alarm							(RW)
 Bit 4: 1 if alarm cause measured temp is over the warning threshold     (R)
 Bit 5: 1 if alarm cause measured volt is over the max threshold         (R)
 Bit 6: 1 if alarm cause measured volt is under the min threshold        (R)
-Bit 7: Volt sensor: Shutdown if alarm persist for more then 4 seconds   (RW)
+Bit 7: Volt sensor: Shutdown if alarm persist for more than 4 seconds   (RW)
        Temp sensor: Shutdown if temp is over the shutdown threshold     (RW)
 
 *  This bit is only honored/used by the uGuru if a temp sensor is connected
@@ -293,7 +293,7 @@ Byte 0:
 Alarm behaviour for the selected sensor. A 1 enables the described behaviour.
 Bit 0: Give an alarm if measured rpm is under the min threshold (RW)
 Bit 3: Beep if alarm                                            (RW)
-Bit 7: Shutdown if alarm persist for more then 4 seconds        (RW)
+Bit 7: Shutdown if alarm persist for more than 4 seconds        (RW)
 
 Byte 1:
 min threshold (scale as bank 0x26)