1 files changed, 5 insertions, 5 deletions

diff --git a/Documentation/DocBook/libata.tmpl b/Documentation/DocBook/libata.tmpl
index 8c5411cfeaf0..cdd1bb9aac0d 100644
--- a/Documentation/DocBook/libata.tmpl
+++ b/Documentation/DocBook/libata.tmpl
@@ -1032,7 +1032,7 @@ and other resources, etc.
            <listitem>
            <para>
            This is indicated by ICRC bit in the ERROR register and
-           means that corruption occurred during data transfer.  Upto
+           means that corruption occurred during data transfer.  Up to
            ATA/ATAPI-7, the standard specifies that this bit is only
            applicable to UDMA transfers but ATA/ATAPI-8 draft revision
            1f says that the bit may be applicable to multiword DMA and
@@ -1045,10 +1045,10 @@ and other resources, etc.
            <term>ABRT error during data transfer or on completion</term>
            <listitem>
            <para>
-           Upto ATA/ATAPI-7, the standard specifies that ABRT could be
+           Up to ATA/ATAPI-7, the standard specifies that ABRT could be
            set on ICRC errors and on cases where a device is not able
            to complete a command.  Combined with the fact that MWDMA
-           and PIO transfer errors aren't allowed to use ICRC bit upto
+           and PIO transfer errors aren't allowed to use ICRC bit up to
            ATA/ATAPI-7, it seems to imply that ABRT bit alone could
            indicate tranfer errors.
            </para>
@@ -1122,7 +1122,7 @@ and other resources, etc.
         <para>
         Depending on commands, not all STATUS/ERROR bits are
         applicable.  These non-applicable bits are marked with
-        &quot;na&quot; in the output descriptions but upto ATA/ATAPI-7
+        &quot;na&quot; in the output descriptions but up to ATA/ATAPI-7
         no definition of &quot;na&quot; can be found.  However,
         ATA/ATAPI-8 draft revision 1f describes &quot;N/A&quot; as
         follows.
@@ -1507,7 +1507,7 @@ and other resources, etc.
 
         <listitem>
         <para>
-        CHS set up with INITIALIZE DEVICE PARAMETERS (seldomly used)
+        CHS set up with INITIALIZE DEVICE PARAMETERS (seldom used)
         </para>
         </listitem>