8 files changed, 42 insertions, 36 deletions

diff --git a/arch/arm/mach-omap1/board-fsample.c b/arch/arm/mach-omap1/board-fsample.c
index 149fdd32e127..295ab6713670 100644
--- a/arch/arm/mach-omap1/board-fsample.c
+++ b/arch/arm/mach-omap1/board-fsample.c
@@ -120,6 +120,15 @@ static struct resource smc91x_resources[] = {
         },
 };
 
+static void __init fsample_init_smc91x(void)
+{
+        fpga_write(1, H2P2_DBG_FPGA_LAN_RESET);
+        mdelay(50);
+        fpga_write(fpga_read(H2P2_DBG_FPGA_LAN_RESET) & ~1,
+                   H2P2_DBG_FPGA_LAN_RESET);
+        mdelay(50);
+}
+
 static struct mtd_partition nor_partitions[] = {
         /* bootloader (U-Boot, etc) in first sector */
         {
@@ -285,6 +294,8 @@ static struct omap_board_config_kernel fsample_config[] = {
 
 static void __init omap_fsample_init(void)
 {
+        fsample_init_smc91x();
+
         if (gpio_request(FSAMPLE_NAND_RB_GPIO_PIN, "NAND ready") < 0)
                 BUG();
         gpio_direction_input(FSAMPLE_NAND_RB_GPIO_PIN);
@@ -312,21 +323,11 @@ static void __init omap_fsample_init(void)
         omap_register_i2c_bus(1, 100, NULL, 0);
 }
 
-static void __init fsample_init_smc91x(void)
-{
-        fpga_write(1, H2P2_DBG_FPGA_LAN_RESET);
-        mdelay(50);
-        fpga_write(fpga_read(H2P2_DBG_FPGA_LAN_RESET) & ~1,
-                   H2P2_DBG_FPGA_LAN_RESET);
-        mdelay(50);
-}
-
 static void __init omap_fsample_init_irq(void)
 {
         omap1_init_common_hw();
         omap_init_irq();
         omap_gpio_init();
-        fsample_init_smc91x();
 }
 
 /* Only FPGA needs to be mapped here. All others are done with ioremap */
diff --git a/arch/arm/mach-omap1/board-h2.c b/arch/arm/mach-omap1/board-h2.c
index 197adb49dc5a..dd35efdefcf7 100644
--- a/arch/arm/mach-omap1/board-h2.c
+++ b/arch/arm/mach-omap1/board-h2.c
@@ -375,7 +375,6 @@ static void __init h2_init_irq(void)
         omap1_init_common_hw();
         omap_init_irq();
         omap_gpio_init();
-        h2_init_smc91x();
 }
 
 static struct omap_usb_config h2_usb_config __initdata = {
@@ -403,6 +402,8 @@ static struct omap_board_config_kernel h2_config[] __initdata = {
 
 static void __init h2_init(void)
 {
+        h2_init_smc91x();
+
         /* Here we assume the NOR boot config:  NOR on CS3 (possibly swapped
          * to address 0 by a dip switch), NAND on CS2B.  The NAND driver will
          * notice whether a NAND chip is enabled at probe time.
diff --git a/arch/arm/mach-omap1/board-h3.c b/arch/arm/mach-omap1/board-h3.c
index 9126e3e37b4a..78719198809e 100644
--- a/arch/arm/mach-omap1/board-h3.c
+++ b/arch/arm/mach-omap1/board-h3.c
@@ -264,6 +264,15 @@ static struct platform_device smc91x_device = {
         .resource       = smc91x_resources,
 };
 
+static void __init h3_init_smc91x(void)
+{
+        omap_cfg_reg(W15_1710_GPIO40);
+        if (gpio_request(40, "SMC91x irq") < 0) {
+                printk("Error requesting gpio 40 for smc91x irq\n");
+                return;
+        }
+}
+
 #define GPTIMER_BASE            0xFFFB1400
 #define GPTIMER_REGS(x) (0xFFFB1400 + (x * 0x800))
 #define GPTIMER_REGS_SIZE       0x46
@@ -376,6 +385,8 @@ static struct i2c_board_info __initdata h3_i2c_board_info[] = {
 
 static void __init h3_init(void)
 {
+        h3_init_smc91x();
+
         /* Here we assume the NOR boot config:  NOR on CS3 (possibly swapped
          * to address 0 by a dip switch), NAND on CS2B.  The NAND driver will
          * notice whether a NAND chip is enabled at probe time.
@@ -422,21 +433,11 @@ static void __init h3_init(void)
         h3_mmc_init();
 }
 
-static void __init h3_init_smc91x(void)
-{
-        omap_cfg_reg(W15_1710_GPIO40);
-        if (gpio_request(40, "SMC91x irq") < 0) {
-                printk("Error requesting gpio 40 for smc91x irq\n");
-                return;
-        }
-}
-
 static void __init h3_init_irq(void)
 {
         omap1_init_common_hw();
         omap_init_irq();
         omap_gpio_init();
-        h3_init_smc91x();
 }
 
 static void __init h3_map_io(void)
diff --git a/arch/arm/mach-omap1/board-innovator.c b/arch/arm/mach-omap1/board-innovator.c
index dc2b86fd66c1..0feaa6731c7e 100644
--- a/arch/arm/mach-omap1/board-innovator.c
+++ b/arch/arm/mach-omap1/board-innovator.c
@@ -296,7 +296,6 @@ static void __init innovator_init_irq(void)
                 omap1510_fpga_init_irq();
         }
 #endif
-        innovator_init_smc91x();
 }
 
 #ifdef CONFIG_ARCH_OMAP15XX
@@ -387,6 +386,8 @@ static struct omap_board_config_kernel innovator_config[] = {
 
 static void __init innovator_init(void)
 {
+        innovator_init_smc91x();
+
 #ifdef CONFIG_ARCH_OMAP15XX
         if (cpu_is_omap1510()) {
                 unsigned char reg;
diff --git a/arch/arm/mach-omap1/board-osk.c b/arch/arm/mach-omap1/board-osk.c
index e9dd79149a8e..30bdbdb93636 100644
--- a/arch/arm/mach-omap1/board-osk.c
+++ b/arch/arm/mach-omap1/board-osk.c
@@ -284,8 +284,6 @@ static void __init osk_init_irq(void)
         omap1_init_common_hw();
         omap_init_irq();
         omap_gpio_init();
-        osk_init_smc91x();
-        osk_init_cf();
 }
 
 static struct omap_usb_config osk_usb_config __initdata = {
@@ -541,6 +539,9 @@ static void __init osk_init(void)
 {
         u32 l;
 
+        osk_init_smc91x();
+        osk_init_cf();
+
         /* Workaround for wrong CS3 (NOR flash) timing
          * There are some U-Boot versions out there which configure
          * wrong CS3 memory timings. This mainly leads to CRC
diff --git a/arch/arm/mach-omap1/board-perseus2.c b/arch/arm/mach-omap1/board-perseus2.c
index a8d16a255c18..07660be4f228 100644
--- a/arch/arm/mach-omap1/board-perseus2.c
+++ b/arch/arm/mach-omap1/board-perseus2.c
@@ -251,8 +251,19 @@ static struct omap_board_config_kernel perseus2_config[] __initdata = {
         { OMAP_TAG_LCD,         &perseus2_lcd_config },
 };
 
+static void __init perseus2_init_smc91x(void)
+{
+        fpga_write(1, H2P2_DBG_FPGA_LAN_RESET);
+        mdelay(50);
+        fpga_write(fpga_read(H2P2_DBG_FPGA_LAN_RESET) & ~1,
+                   H2P2_DBG_FPGA_LAN_RESET);
+        mdelay(50);
+}
+
 static void __init omap_perseus2_init(void)
 {
+        perseus2_init_smc91x();
+
         if (gpio_request(P2_NAND_RB_GPIO_PIN, "NAND ready") < 0)
                 BUG();
         gpio_direction_input(P2_NAND_RB_GPIO_PIN);
@@ -280,21 +291,11 @@ static void __init omap_perseus2_init(void)
         omap_register_i2c_bus(1, 100, NULL, 0);
 }
 
-static void __init perseus2_init_smc91x(void)
-{
-        fpga_write(1, H2P2_DBG_FPGA_LAN_RESET);
-        mdelay(50);
-        fpga_write(fpga_read(H2P2_DBG_FPGA_LAN_RESET) & ~1,
-                   H2P2_DBG_FPGA_LAN_RESET);
-        mdelay(50);
-}
-
 static void __init omap_perseus2_init_irq(void)
 {
         omap1_init_common_hw();
         omap_init_irq();
         omap_gpio_init();
-        perseus2_init_smc91x();
 }
 /* Only FPGA needs to be mapped here. All others are done with ioremap */
 static struct map_desc omap_perseus2_io_desc[] __initdata = {
diff --git a/arch/arm/mach-omap2/board-apollon.c b/arch/arm/mach-omap2/board-apollon.c
index 2c6db1aaeb29..6ae777e08896 100644
--- a/arch/arm/mach-omap2/board-apollon.c
+++ b/arch/arm/mach-omap2/board-apollon.c
@@ -281,7 +281,6 @@ static void __init omap_apollon_init_irq(void)
         omap2_init_common_hw(NULL, NULL);
         omap_init_irq();
         omap_gpio_init();
-        apollon_init_smc91x();
 }
 
 static void __init apollon_led_init(void)
@@ -324,6 +323,7 @@ static void __init omap_apollon_init(void)
 
         omap2420_mux_init(board_mux, OMAP_PACKAGE_ZAC);
 
+        apollon_init_smc91x();
         apollon_led_init();
         apollon_flash_init();
         apollon_usb_init();
diff --git a/arch/arm/mach-omap2/board-ldp.c b/arch/arm/mach-omap2/board-ldp.c
index 001fd9713f39..3dab44e3eb42 100644
--- a/arch/arm/mach-omap2/board-ldp.c
+++ b/arch/arm/mach-omap2/board-ldp.c
@@ -295,7 +295,6 @@ static void __init omap_ldp_init_irq(void)
         omap2_init_common_hw(NULL, NULL);
         omap_init_irq();
         omap_gpio_init();
-        ldp_init_smsc911x();
 }
 
 static struct twl4030_usb_data ldp_usb_data = {
@@ -426,6 +425,7 @@ static struct mtd_partition ldp_nand_partitions[] = {
 static void __init omap_ldp_init(void)
 {
         omap3_mux_init(board_mux, OMAP_PACKAGE_CBB);
+        ldp_init_smsc911x();
         omap_i2c_init();
         platform_add_devices(ldp_devices, ARRAY_SIZE(ldp_devices));
         ts_gpio = 54;