mac80211: adding 802.11n configuration flows

This patch configures the 802.11n mode of operation
internally in ieee80211_conf structure and in the low-level
driver as well (through op conf_ht).
It does not include AP configuration flows.

Signed-off-by: Ron Rindjunsky <ron.rindjunsky@intel.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

3 files changed, 86 insertions, 0 deletions

diff --git a/net/mac80211/ieee80211.c b/net/mac80211/ieee80211.c
index 4f8b6653e364..d6a97a68a62e 100644
--- a/net/mac80211/ieee80211.c
+++ b/net/mac80211/ieee80211.c
@@ -34,6 +34,8 @@
 #include "debugfs.h"
 #include "debugfs_netdev.h"
 
+#define SUPP_MCS_SET_LEN 16
+
 /*
  * For seeing transmitted packets on monitor interfaces
  * we have a radiotap header too.
@@ -563,6 +565,55 @@ int ieee80211_hw_config(struct ieee80211_local *local)
         return ret;
 }
 
+/**
+ * ieee80211_hw_config_ht should be used only after legacy configuration
+ * has been determined, as ht configuration depends upon the hardware's
+ * HT abilities for a _specific_ band.
+ */
+int ieee80211_hw_config_ht(struct ieee80211_local *local, int enable_ht,
+                           struct ieee80211_ht_info *req_ht_cap,
+                           struct ieee80211_ht_bss_info *req_bss_cap)
+{
+        struct ieee80211_conf *conf = &local->hw.conf;
+        struct ieee80211_hw_mode *mode = conf->mode;
+        int i;
+
+        /* HT is not supported */
+        if (!mode->ht_info.ht_supported) {
+                conf->flags &= ~IEEE80211_CONF_SUPPORT_HT_MODE;
+                return -EOPNOTSUPP;
+        }
+
+        /* disable HT */
+        if (!enable_ht) {
+                conf->flags &= ~IEEE80211_CONF_SUPPORT_HT_MODE;
+        } else {
+                conf->flags |= IEEE80211_CONF_SUPPORT_HT_MODE;
+                conf->ht_conf.cap = req_ht_cap->cap & mode->ht_info.cap;
+                conf->ht_conf.cap &= ~(IEEE80211_HT_CAP_MIMO_PS);
+                conf->ht_conf.cap |=
+                        mode->ht_info.cap & IEEE80211_HT_CAP_MIMO_PS;
+                conf->ht_bss_conf.primary_channel =
+                        req_bss_cap->primary_channel;
+                conf->ht_bss_conf.bss_cap = req_bss_cap->bss_cap;
+                conf->ht_bss_conf.bss_op_mode = req_bss_cap->bss_op_mode;
+                for (i = 0; i < SUPP_MCS_SET_LEN; i++)
+                        conf->ht_conf.supp_mcs_set[i] =
+                                mode->ht_info.supp_mcs_set[i] &
+                                  req_ht_cap->supp_mcs_set[i];
+
+                /* In STA mode, this gives us indication
+                 * to the AP's mode of operation */
+                conf->ht_conf.ht_supported = 1;
+                conf->ht_conf.ampdu_factor = req_ht_cap->ampdu_factor;
+                conf->ht_conf.ampdu_density = req_ht_cap->ampdu_density;
+        }
+
+        local->ops->conf_ht(local_to_hw(local), &local->hw.conf);
+
+        return 0;
+}
+
 void ieee80211_erp_info_change_notify(struct net_device *dev, u8 changes)
 {
         struct ieee80211_local *local = wdev_priv(dev->ieee80211_ptr);
diff --git a/net/mac80211/ieee80211_i.h b/net/mac80211/ieee80211_i.h
index 66b6cf3a62ac..2dcb9425fe8f 100644
--- a/net/mac80211/ieee80211_i.h
+++ b/net/mac80211/ieee80211_i.h
@@ -708,6 +708,9 @@ int ieee80211_if_update_wds(struct net_device *dev, u8 *remote_addr);
 void ieee80211_if_setup(struct net_device *dev);
 struct ieee80211_rate *ieee80211_get_rate(struct ieee80211_local *local,
                                           int phymode, int hwrate);
+int ieee80211_hw_config_ht(struct ieee80211_local *local, int enable_ht,
+                           struct ieee80211_ht_info *req_ht_cap,
+                           struct ieee80211_ht_bss_info *req_bss_cap);
 
 /* ieee80211_ioctl.c */
 extern const struct iw_handler_def ieee80211_iw_handler_def;
diff --git a/net/mac80211/ieee80211_sta.c b/net/mac80211/ieee80211_sta.c
index 1d553d78b227..87830c04a1ca 100644
--- a/net/mac80211/ieee80211_sta.c
+++ b/net/mac80211/ieee80211_sta.c
@@ -1437,6 +1437,19 @@ static void ieee80211_rx_mgmt_assoc_resp(struct net_device *dev,
         }
         sta->supp_rates = rates;
 
+        if (elems.ht_cap_elem && elems.ht_info_elem && elems.wmm_param &&
+            local->ops->conf_ht) {
+                struct ieee80211_ht_bss_info bss_info;
+
+                ieee80211_ht_cap_ie_to_ht_info(
+                                (struct ieee80211_ht_cap *)
+                                elems.ht_cap_elem, &sta->ht_info);
+                ieee80211_ht_addt_info_ie_to_ht_bss_info(
+                                (struct ieee80211_ht_addt_info *)
+                                elems.ht_info_elem, &bss_info);
+                ieee80211_hw_config_ht(local, 1, &sta->ht_info, &bss_info);
+        }
+
         rate_control_rate_init(sta, local);
 
         if (elems.wmm_param && (ifsta->flags & IEEE80211_STA_WMM_ENABLED)) {
@@ -1859,6 +1872,8 @@ static void ieee80211_rx_mgmt_beacon(struct net_device *dev,
         struct ieee80211_if_sta *ifsta;
         size_t baselen;
         struct ieee802_11_elems elems;
+        struct ieee80211_local *local = wdev_priv(dev->ieee80211_ptr);
+        struct ieee80211_conf *conf = &local->hw.conf;
 
         ieee80211_rx_bss_info(dev, mgmt, len, rx_status, 1);
 
@@ -1881,6 +1896,23 @@ static void ieee80211_rx_mgmt_beacon(struct net_device *dev,
         if (elems.erp_info && elems.erp_info_len >= 1)
                 ieee80211_handle_erp_ie(dev, elems.erp_info[0]);
 
+        if (elems.ht_cap_elem && elems.ht_info_elem &&
+            elems.wmm_param && local->ops->conf_ht &&
+            conf->flags & IEEE80211_CONF_SUPPORT_HT_MODE) {
+                struct ieee80211_ht_bss_info bss_info;
+
+                ieee80211_ht_addt_info_ie_to_ht_bss_info(
+                                (struct ieee80211_ht_addt_info *)
+                                elems.ht_info_elem, &bss_info);
+                /* check if AP changed bss inforamation */
+                if ((conf->ht_bss_conf.primary_channel !=
+                     bss_info.primary_channel) ||
+                    (conf->ht_bss_conf.bss_cap != bss_info.bss_cap) ||
+                    (conf->ht_bss_conf.bss_op_mode != bss_info.bss_op_mode))
+                        ieee80211_hw_config_ht(local, 1, &conf->ht_conf,
+                                                &bss_info);
+        }
+
         if (elems.wmm_param && (ifsta->flags & IEEE80211_STA_WMM_ENABLED)) {
                 ieee80211_sta_wmm_params(dev, ifsta, elems.wmm_param,
                                          elems.wmm_param_len);