phy: add the EEE support and the way to access to the MMD registers.

This patch adds the support for the Energy-Efficient Ethernet (EEE)
to the Physical Abstraction Layer.
To support the EEE we have to access to the MMD registers 3.20 and
7.60/61. So two new functions have been added to read/write the MMD
registers (clause 45).

An Ethernet driver (I tested the stmmac) can invoke the phy_init_eee to properly
check if the EEE is supported by the PHYs and it can also set the clock
stop enable bit in the 3.0 register.
The phy_get_eee_err can be used for reporting the number of time where
the PHY failed to complete its normal wake sequence.

In the end, this patch also adds the EEE ethtool support implementing:
 o phy_ethtool_set_eee
 o phy_ethtool_get_eee

v1: initial patch
v2: fixed some errors especially on naming convention
v3: renamed again the mmd read/write functions thank to Ben's feedback
v4: moved file to phy.c and added the ethtool support.
v5: fixed phy_adv_to_eee, phy_eee_to_supported, phy_eee_to_adv return
    values according to ethtool API (thanks to Ben's feedback).
    Renamed some macros to avoid too long names.
v6: fixed kernel-doc comments to be properly parsed.
    Fixed the phy_init_eee function: we need to check which link mode
    was autonegotiated and then the corresponding bits in 7.60 and 7.61
    registers.
v7: reviewed the way to get the negotiated settings.
v8: fixed a problem in the phy_init_eee return value erroneously added
    when included the phy_read_status call.
v9: do not remove the MDIO_AN_EEE_ADV_100TX and MDIO_AN_EEE_ADV_1000T
    and fixed the eee_{cap,lp,adv} declaration as "int" instead of u16.

Signed-off-by: Giuseppe Cavallaro <peppe.cavallaro@st.com>
Reviewed-by: Ben Hutchings <bhutchings@solarflare.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

1 files changed, 5 insertions, 0 deletions

diff --git a/include/linux/phy.h b/include/linux/phy.h
index 7eac80a2557b..c35299e4da8e 100644
--- a/include/linux/phy.h
+++ b/include/linux/phy.h
@@ -554,6 +554,11 @@ int phy_register_fixup_for_uid(u32 phy_uid, u32 phy_uid_mask,
                 int (*run)(struct phy_device *));
 int phy_scan_fixups(struct phy_device *phydev);
 
+int phy_init_eee(struct phy_device *phydev, bool clk_stop_enable);
+int phy_get_eee_err(struct phy_device *phydev);
+int phy_ethtool_set_eee(struct phy_device *phydev, struct ethtool_eee *data);
+int phy_ethtool_get_eee(struct phy_device *phydev, struct ethtool_eee *data);
+
 int __init mdio_bus_init(void);
 void mdio_bus_exit(void);