mmc: Fixes for Dual Data Rate (DDR) support

The DDR support patch needs the following fixes:

- The block driver does not need to know about DDR, any more
  than it needs to know about bus width.
- Not only the card must be switched to DDR mode.  The host
  controller must also be configured, which is done through
  the 'set_ios()' function.
- Do not set the DDR mode state until after the switch command
  is successful.
- Setting block length is not supported in DDR mode.  Make that
  a core function and change the other place it is used (mmc_test)
  also.

Signed-off-by: Adrian Hunter <adrian.hunter@nokia.com>
Signed-off-by: Chris Ball <cjb@laptop.org>

2 files changed, 7 insertions, 1 deletions

diff --git a/include/linux/mmc/core.h b/include/linux/mmc/core.h
index d0fbcacab52c..64e013f1cfb8 100644
--- a/include/linux/mmc/core.h
+++ b/include/linux/mmc/core.h
@@ -109,7 +109,6 @@ struct mmc_data {
 #define MMC_DATA_WRITE  (1 << 8)
 #define MMC_DATA_READ   (1 << 9)
 #define MMC_DATA_STREAM (1 << 10)
-#define MMC_DDR_MODE    (1 << 11)
 
         unsigned int            bytes_xfered;
 
@@ -154,6 +153,8 @@ extern int mmc_can_secure_erase_trim(struct mmc_card *card);
 extern int mmc_erase_group_aligned(struct mmc_card *card, unsigned int from,
                                    unsigned int nr);
 
+extern int mmc_set_blocklen(struct mmc_card *card, unsigned int blocklen);
+
 extern void mmc_set_data_timeout(struct mmc_data *, const struct mmc_card *);
 extern unsigned int mmc_align_data_size(struct mmc_card *, unsigned int);
 
diff --git a/include/linux/mmc/host.h b/include/linux/mmc/host.h
index 6711eb8715ba..c4fb1c5efc44 100644
--- a/include/linux/mmc/host.h
+++ b/include/linux/mmc/host.h
@@ -50,6 +50,11 @@ struct mmc_ios {
 #define MMC_TIMING_LEGACY       0
 #define MMC_TIMING_MMC_HS       1
 #define MMC_TIMING_SD_HS        2
+
+        unsigned char   ddr;                    /* dual data rate used */
+
+#define MMC_SDR_MODE            0
+#define MMC_DDR_MODE            1
 };
 
 struct mmc_host_ops {