drm: initial KMS config fixes

When mode setting is first initialized, the driver will call into
drm_helper_initial_config() to set up an initial output and framebuffer
configuration.  This routine is responsible for probing the available
connectors, encoders, and crtcs, looking for modes and putting together
something reasonable (where reasonable is defined as "allows kernel
messages to be visible on as many displays as possible").

However, the code was a bit too aggressive in setting default modes when
none were found on a given connector.  Even if some connectors had modes,
any connectors found lacking modes would have the default 800x600 mode added
to their mode list, which in some cases could cause problems later down the
line.  In my case, the LVDS was perfectly available, but the initial config
code added 800x600 modes to both of the detected but unavailable HDMI
connectors (which are on my non-existent docking station).  This ended up
preventing later code from setting a mode on my LVDS, which is bad.

This patch fixes that behavior by making the initial config code walk
through the connectors first, counting the available modes, before it decides
to add any default modes to a possibly connected output.  It also fixes the
logic in drm_target_preferred() that was causing zeroed out modes to be set
as the preferred mode for a given connector, even if no modes were available.

Signed-off-by: Jesse Barnes <jbarnes@virtuousgeek.org>
Signed-off-by: Eric Anholt <eric@anholt.net>
Signed-off-by: Dave Airlie <airlied@linux.ie>

1 files changed, 1 insertions, 1 deletions

diff --git a/include/drm/drm_crtc.h b/include/drm/drm_crtc.h
index 0acb07f31fa4..47809ac94bc3 100644
--- a/include/drm/drm_crtc.h
+++ b/include/drm/drm_crtc.h
@@ -395,7 +395,7 @@ struct drm_connector_funcs {
         void (*save)(struct drm_connector *connector);
         void (*restore)(struct drm_connector *connector);
         enum drm_connector_status (*detect)(struct drm_connector *connector);
-        void (*fill_modes)(struct drm_connector *connector, uint32_t max_width, uint32_t max_height);
+        int (*fill_modes)(struct drm_connector *connector, uint32_t max_width, uint32_t max_height);
         int (*set_property)(struct drm_connector *connector, struct drm_property *property,
                              uint64_t val);
         void (*destroy)(struct drm_connector *connector);