mv643xx_eth: fix unicast address filter corruption on mtu change

When mv643xx_eth_open() is called to up an interface, port_start()
will first re-program the unicast address filter, and then
re-initialise the PORT_CONFIG register, but that will disable unicast
promiscuous mode if it was enabled by the unicast address filter setup.

This isn't a problem on ifconfig up, as ->set_rx_mode() will be called
shortly afterwards which will program the filters again, but it does
trigger when changing the MTU, which calls mv643xx_eth_stop() and then
mv643xx_eth_open() by hand to repopulate the receive rings with skbuffs
of the new size.

Swap the initialisation of the PORT_START register and the call to
the unicast filter setup function to fix this.

Signed-off-by: Lennert Buytenhek <buytenh@marvell.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

1 files changed, 5 insertions, 5 deletions

diff --git a/drivers/net/mv643xx_eth.c b/drivers/net/mv643xx_eth.c
index 13f11f402a99..b0bc3bc18e9c 100644
--- a/drivers/net/mv643xx_eth.c
+++ b/drivers/net/mv643xx_eth.c
@@ -2030,11 +2030,6 @@ static void port_start(struct mv643xx_eth_private *mp)
         }
 
         /*
-         * Add configured unicast address to address filter table.
-         */
-        mv643xx_eth_program_unicast_filter(mp->dev);
-
-        /*
          * Receive all unmatched unicast, TCP, UDP, BPDU and broadcast
          * frames to RX queue #0, and include the pseudo-header when
          * calculating receive checksums.
@@ -2047,6 +2042,11 @@ static void port_start(struct mv643xx_eth_private *mp)
         wrlp(mp, PORT_CONFIG_EXT, 0x00000000);
 
         /*
+         * Add configured unicast addresses to address filter table.
+         */
+        mv643xx_eth_program_unicast_filter(mp->dev);
+
+        /*
          * Enable the receive queues.
          */
         for (i = 0; i < mp->rxq_count; i++) {