USB: phy: remove custom DBG macro

Use the in-kernel pr_debug() calls instead of trying to roll your own
DBG macro.  This means the dynamic debugging calls now work here, and
there is no dependency on CONFIG_USB_DEBUG for the phy code anymore.

Acked-by: Felipe Balbi <balbi@ti.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

1 files changed, 3 insertions, 3 deletions

diff --git a/drivers/usb/phy/phy-fsl-usb.c b/drivers/usb/phy/phy-fsl-usb.c
index e771bafb9f1d..181bfb10a57a 100644
--- a/drivers/usb/phy/phy-fsl-usb.c
+++ b/drivers/usb/phy/phy-fsl-usb.c
@@ -611,7 +611,7 @@ static int fsl_otg_set_peripheral(struct usb_otg *otg,
         otg_dev->fsm.b_bus_req = 1;
 
         /* start the gadget right away if the ID pin says Mini-B */
-        DBG("ID pin=%d\n", otg_dev->fsm.id);
+        pr_debug("ID pin=%d\n", otg_dev->fsm.id);
         if (otg_dev->fsm.id == 1) {
                 fsl_otg_start_host(&otg_dev->fsm, 0);
                 otg_drv_vbus(&otg_dev->fsm, 0);
@@ -684,7 +684,7 @@ static int fsl_otg_start_hnp(struct usb_otg *otg)
         if (otg_dev != fsl_otg_dev)
                 return -ENODEV;
 
-        DBG("start_hnp...n");
+        pr_debug("start_hnp...\n");
 
         /* clear a_bus_req to enter a_suspend state */
         otg_dev->fsm.a_bus_req = 0;
@@ -941,7 +941,7 @@ int usb_otg_start(struct platform_device *pdev)
                 p_otg->fsm.id = 0;
         }
 
-        DBG("initial ID pin=%d\n", p_otg->fsm.id);
+        pr_debug("initial ID pin=%d\n", p_otg->fsm.id);
 
         /* enable OTG ID pin interrupt */
         temp = fsl_readl(&p_otg->dr_mem_map->otgsc);