spi: new spi->mode bits

Add two new spi_device.mode bits to accomodate more protocol options, and
pass them through to usermode drivers:

 * SPI_NO_CS ... a second 3-wire variant, where the chipselect
   line is removed instead of a data line; transfers are still
   full duplex.

   This obviously has STRONG protocol implications since the
   chipselect transitions can't be used to synchronize state
   transitions with the SPI master.

 * SPI_READY ... defines open drain signal that's pulled low
   to pause the clock.  This defines a 5-wire variant (normal
   4-wire SPI plus READY) and two 4-wire variants (READY plus
   each of the 3-wire flavors).

   Such hardware flow control can be a big win.  There are ADC
   converters and flash chips that expose READY signals, but not
   many host controllers support it today.

The spi_bitbang code should be changed to use SPI_NO_CS instead of its
current nonportable hack.  That's a mode most hardware can easily support
(unlike SPI_READY).

Signed-off-by: David Brownell <dbrownell@users.sourceforge.net>
Cc: "Paulraj, Sandeep" <s-paulraj@ti.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

1 files changed, 11 insertions, 6 deletions

diff --git a/drivers/spi/spidev.c b/drivers/spi/spidev.c
index 5d869c4d3eb2..606e7a40a8da 100644
--- a/drivers/spi/spidev.c
+++ b/drivers/spi/spidev.c
@@ -58,15 +58,20 @@ static unsigned long	minors[N_SPI_MINORS / BITS_PER_LONG];
 
 
 /* Bit masks for spi_device.mode management.  Note that incorrect
- * settings for CS_HIGH and 3WIRE can cause *lots* of trouble for other
- * devices on a shared bus:  CS_HIGH, because this device will be
- * active when it shouldn't be;  3WIRE, because when active it won't
- * behave as it should.
+ * settings for some settings can cause *lots* of trouble for other
+ * devices on a shared bus:
  *
- * REVISIT should changing those two modes be privileged?
+ *  - CS_HIGH ... this device will be active when it shouldn't be
+ *  - 3WIRE ... when active, it won't behave as it should
+ *  - NO_CS ... there will be no explicit message boundaries; this
+ *      is completely incompatible with the shared bus model
+ *  - READY ... transfers may proceed when they shouldn't.
+ *
+ * REVISIT should changing those flags be privileged?
  */
 #define SPI_MODE_MASK           (SPI_CPHA | SPI_CPOL | SPI_CS_HIGH \
-                                | SPI_LSB_FIRST | SPI_3WIRE | SPI_LOOP)
+                                | SPI_LSB_FIRST | SPI_3WIRE | SPI_LOOP \
+                                | SPI_NO_CS | SPI_READY)
 
 struct spidev_data {
         dev_t                   devt;