[ARM] pxa: correct SSCR0_SCR to support multiple SoCs

The previous definitions of SSCR0_SCR and SSCR0_SerClkDiv() prevented
them being used simultaneously when supporting multiple PXA SoCs, esp.
in drivers/spi/pxa2xx_spi.c, make them correct.

The change from SSCR0_SerClkDiv(2) to SSCR0_SCR(2), will make the result
a little bit different in pxa2xx_spi_probe(), however, since that's only
used as a default initialization value, it's acceptable.

Signed-off-by: Eric Miao <eric.y.miao@gmail.com>

1 files changed, 7 insertions, 7 deletions

diff --git a/drivers/spi/pxa2xx_spi.c b/drivers/spi/pxa2xx_spi.c
index 36828358a4d8..35d4e5cdb631 100644
--- a/drivers/spi/pxa2xx_spi.c
+++ b/drivers/spi/pxa2xx_spi.c
@@ -1318,14 +1318,14 @@ static int setup(struct spi_device *spi)
         /* NOTE:  PXA25x_SSP _could_ use external clocking ... */
         if (drv_data->ssp_type != PXA25x_SSP)
                 dev_dbg(&spi->dev, "%ld Hz actual, %s\n",
-                                clk_get_rate(ssp->clk)
-                                        / (1 + ((chip->cr0 & SSCR0_SCR) >> 8)),
-                                chip->enable_dma ? "DMA" : "PIO");
+                        clk_get_rate(ssp->clk)
+                                / (1 + ((chip->cr0 & SSCR0_SCR(0xfff)) >> 8)),
+                        chip->enable_dma ? "DMA" : "PIO");
         else
                 dev_dbg(&spi->dev, "%ld Hz actual, %s\n",
-                                clk_get_rate(ssp->clk) / 2
-                                        / (1 + ((chip->cr0 & SSCR0_SCR) >> 8)),
-                                chip->enable_dma ? "DMA" : "PIO");
+                        clk_get_rate(ssp->clk) / 2
+                                / (1 + ((chip->cr0 & SSCR0_SCR(0x0ff)) >> 8)),
+                        chip->enable_dma ? "DMA" : "PIO");
 
         if (spi->bits_per_word <= 8) {
                 chip->n_bytes = 1;
@@ -1558,7 +1558,7 @@ static int __init pxa2xx_spi_probe(struct platform_device *pdev)
         write_SSCR1(SSCR1_RxTresh(RX_THRESH_DFLT) |
                                 SSCR1_TxTresh(TX_THRESH_DFLT),
                                 drv_data->ioaddr);
-        write_SSCR0(SSCR0_SerClkDiv(2)
+        write_SSCR0(SSCR0_SCR(2)
                         | SSCR0_Motorola
                         | SSCR0_DataSize(8),
                         drv_data->ioaddr);