spi: SuperH MSIOF SPI Master driver V2

This patch is V2 of SPI Master support for the SuperH MSIOF.
Full duplex, spi mode 0-3, active high cs, 3-wire and lsb
first should all be supported, but the driver has so far
only been tested with "mmc_spi".

The MSIOF hardware comes with 32-bit FIFOs for receive and
transmit, and this driver simply breaks the SPI messages
into FIFO-sized chunks. The MSIOF hardware manages the pins
for clock, receive and transmit (sck/miso/mosi), but the chip
select pin is managed by software and must be configured as
a regular GPIO pin by the board code.

Performance wise there is still room for improvement, but
on a Ecovec board with the built-in sh7724 MSIOF0 this driver
gets Mini-sd read speeds of about half a megabyte per second.

Future work include better clock setup and merging of 8-bit
transfers into 32-bit words to reduce interrupt load and
improve throughput.

Signed-off-by: Magnus Damm <damm@opensource.se>
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>

1 files changed, 1 insertions, 0 deletions

diff --git a/drivers/spi/Makefile b/drivers/spi/Makefile
index 2f2bebc63b64..9c51e2526892 100644
--- a/drivers/spi/Makefile
+++ b/drivers/spi/Makefile
@@ -35,6 +35,7 @@ obj-$(CONFIG_SPI_XILINX)		+= xilinx_spi.o
 obj-$(CONFIG_SPI_XILINX_OF)             += xilinx_spi_of.o
 obj-$(CONFIG_SPI_XILINX_PLTFM)          += xilinx_spi_pltfm.o
 obj-$(CONFIG_SPI_SH_SCI)                += spi_sh_sci.o
+obj-$(CONFIG_SPI_SH_MSIOF)              += spi_sh_msiof.o
 obj-$(CONFIG_SPI_STMP3XXX)              += spi_stmp.o
 #       ... add above this line ...