Merge branch 'next-spi' of git://git.secretlab.ca/git/linux-2.6

* 'next-spi' of git://git.secretlab.ca/git/linux-2.6:
  spi: spi_txx9.c: use resource_size()
  spi: spi_sh_sci.c: use resource_size()
  spi: spi_mpc8xxx.c: use resource_size()
  spi: spi_bfin5xx.c: use resource_size()
  spi: atmel_spi.c: use resource_size()
  spi: Add s3c64xx SPI Controller driver
  atmel_spi: fix dma addr calculation for len > BUFFER_SIZE
  spi_s3c24xx: add FIQ pseudo-DMA support
  spi: controller driver for Designware SPI core
  spidev: add proper section markers
  spidev: use DECLARE_BITMAP instead of declaring the array

1 files changed, 28 insertions, 0 deletions

diff --git a/drivers/spi/Kconfig b/drivers/spi/Kconfig
index 2d9d70359360..f55eb0107336 100644
--- a/drivers/spi/Kconfig
+++ b/drivers/spi/Kconfig
@@ -216,6 +216,17 @@ config SPI_S3C24XX
         help
           SPI driver for Samsung S3C24XX series ARM SoCs
 
+config SPI_S3C24XX_FIQ
+        bool "S3C24XX driver with FIQ pseudo-DMA"
+        depends on SPI_S3C24XX
+        select FIQ
+        help
+          Enable FIQ support for the S3C24XX SPI driver to provide pseudo
+          DMA by using the fast-interrupt request framework, This allows
+          the driver to get DMA-like performance when there are either
+          no free DMA channels, or when doing transfers that required both
+          TX and RX data paths.
+
 config SPI_S3C24XX_GPIO
         tristate "Samsung S3C24XX series SPI by GPIO"
         depends on ARCH_S3C2410 && EXPERIMENTAL
@@ -226,6 +237,13 @@ config SPI_S3C24XX_GPIO
           the inbuilt hardware cannot provide the transfer mode, or
           where the board is using non hardware connected pins.
 
+config SPI_S3C64XX
+        tristate "Samsung S3C64XX series type SPI"
+        depends on ARCH_S3C64XX && EXPERIMENTAL
+        select S3C64XX_DMA
+        help
+          SPI driver for Samsung S3C64XX and newer SoCs.
+
 config SPI_SH_MSIOF
         tristate "SuperH MSIOF SPI controller"
         depends on SUPERH && HAVE_CLK
@@ -289,6 +307,16 @@ config SPI_NUC900
 # Add new SPI master controllers in alphabetical order above this line
 #
 
+config SPI_DESIGNWARE
+        bool "DesignWare SPI controller core support"
+        depends on SPI_MASTER
+        help
+          general driver for SPI controller core from DesignWare
+
+config SPI_DW_PCI
+        tristate "PCI interface driver for DW SPI core"
+        depends on SPI_DESIGNWARE && PCI
+
 #
 # There are lots of SPI device types, with sensors and memory
 # being probably the most widely used ones.