parisc: advertise PCI devs after "assign_resources"

Alex Chiang asked me why PARISC was calling pci_bus_add_devices()
and pci_bus_assign_resources() in the opposite order from everyone else.
No reason and I couldn't see any data dependency.
Patch below applies cleanly to 2.6.30-rc2.

Later, I suspected the code worked only because no drivers would be
loaded/ready until much later in the system initialization sequence.

Tested "LBA" code on J6000 (32-bit) and A500 (64-bit SMP) with 2.6.30-rc2.
Not tested with any Dino controllers.
Not tested with PCI-PCI Bridge (TBD).

Reported-by: Alex Chiang <achiang@hp.com>
Signed-off-by: Grant Grundler <grundler@parisc-linux.org>
Signed-off-by: Kyle McMartin <kyle@mcmartin.ca>

1 files changed, 5 insertions, 5 deletions

diff --git a/drivers/parisc/lba_pci.c b/drivers/parisc/lba_pci.c
index 59fbbf128365..f2661e1255af 100644
--- a/drivers/parisc/lba_pci.c
+++ b/drivers/parisc/lba_pci.c
@@ -1509,10 +1509,6 @@ lba_driver_probe(struct parisc_device *dev)
         lba_bus = lba_dev->hba.hba_bus =
                 pci_scan_bus_parented(&dev->dev, lba_dev->hba.bus_num.start,
                                 cfg_ops, NULL);
-        if (lba_bus) {
-                lba_next_bus = lba_bus->subordinate + 1;
-                pci_bus_add_devices(lba_bus);
-        }
 
         /* This is in lieu of calling pci_assign_unassigned_resources() */
         if (is_pdc_pat()) {
@@ -1533,7 +1529,6 @@ lba_driver_probe(struct parisc_device *dev)
         }
         pci_enable_bridges(lba_bus);
 
-
         /*
         ** Once PCI register ops has walked the bus, access to config
         ** space is restricted. Avoids master aborts on config cycles.
@@ -1543,6 +1538,11 @@ lba_driver_probe(struct parisc_device *dev)
                 lba_dev->flags |= LBA_FLAG_SKIP_PROBE;
         }
 
+        if (lba_bus) {
+                lba_next_bus = lba_bus->subordinate + 1;
+                pci_bus_add_devices(lba_bus);
+        }
+
         /* Whew! Finally done! Tell services we got this one covered. */
         return 0;
 }