libertas: Extend MESH_CONFIG command to access non-volatile configuration

This patch is based on a patch from Shailendra Govardhan and Brian Cavagnolo.
It extends the MESH_CONFIG command to configure non-volatile parameters on
libertas devices that support them (e.g. OLPC Active Antenna).

This patch only implements the driver/firmware interface.

See http://dev.laptop.org/ticket/6823 for minimal testing results and known
issues.

Signed-off-by: Javier Cardona <javier@cozybit.com>
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
Signed-off-by: John W. Linville <linville@tuxdriver.com>

1 files changed, 3 insertions, 2 deletions

diff --git a/drivers/net/wireless/libertas/wext.c b/drivers/net/wireless/libertas/wext.c
index 0973d015a520..d4b19f11b785 100644
--- a/drivers/net/wireless/libertas/wext.c
+++ b/drivers/net/wireless/libertas/wext.c
@@ -1002,7 +1002,7 @@ static int lbs_mesh_set_freq(struct net_device *dev,
                 else if (priv->mode == IW_MODE_ADHOC)
                         lbs_stop_adhoc_network(priv);
         }
-        lbs_mesh_config(priv, 1, fwrq->m);
+        lbs_mesh_config(priv, CMD_ACT_MESH_CONFIG_START, fwrq->m);
         lbs_update_channel(priv);
         ret = 0;
 
@@ -2011,7 +2011,8 @@ static int lbs_mesh_set_essid(struct net_device *dev,
                 priv->mesh_ssid_len = dwrq->length;
         }
 
-        lbs_mesh_config(priv, 1, priv->curbssparams.channel);
+        lbs_mesh_config(priv, CMD_ACT_MESH_CONFIG_START,
+                        priv->curbssparams.channel);
  out:
         lbs_deb_leave_args(LBS_DEB_WEXT, "ret %d", ret);
         return ret;