libertas: Extend MESH_CONFIG command to access non-volatile configuration

This patch is based on a patch from Shailendra Govardhan and Brian Cavagnolo.
It extends the MESH_CONFIG command to configure non-volatile parameters on
libertas devices that support them (e.g. OLPC Active Antenna).

This patch only implements the driver/firmware interface.

See http://dev.laptop.org/ticket/6823 for minimal testing results and known
issues.

Signed-off-by: Javier Cardona <javier@cozybit.com>
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
Signed-off-by: John W. Linville <linville@tuxdriver.com>

1 files changed, 17 insertions, 0 deletions

diff --git a/drivers/net/wireless/libertas/host.h b/drivers/net/wireless/libertas/host.h
index 3915c3144fad..c92e41b4faf4 100644
--- a/drivers/net/wireless/libertas/host.h
+++ b/drivers/net/wireless/libertas/host.h
@@ -256,6 +256,23 @@ enum cmd_mesh_access_opts {
         CMD_ACT_MESH_GET_AUTOSTART_ENABLED,
 };
 
+/* Define actions and types for CMD_MESH_CONFIG */
+enum cmd_mesh_config_actions {
+        CMD_ACT_MESH_CONFIG_STOP = 0,
+        CMD_ACT_MESH_CONFIG_START,
+        CMD_ACT_MESH_CONFIG_SET,
+        CMD_ACT_MESH_CONFIG_GET,
+};
+
+enum cmd_mesh_config_types {
+        CMD_TYPE_MESH_SET_BOOTFLAG = 1,
+        CMD_TYPE_MESH_SET_BOOTTIME,
+        CMD_TYPE_MESH_SET_DEF_CHANNEL,
+        CMD_TYPE_MESH_SET_MESH_IE,
+        CMD_TYPE_MESH_GET_DEFAULTS,
+        CMD_TYPE_MESH_GET_MESH_IE, /* GET_DEFAULTS is superset of GET_MESHIE */
+};
+
 /** Card Event definition */
 #define MACREG_INT_CODE_TX_PPA_FREE             0
 #define MACREG_INT_CODE_TX_DMA_DONE             1