spidernet: enable support for bcm5461 ethernet phy

A newer board revision changed the type of ethernet phy.
Moreover, this generalizes the way that a phy gets switched
into fiber mode when autodetection is not available.

Signed-off-by: Jens Osterkamp <Jens.Osterkamp@de.ibm.com>
Signed-off-by: Arnd Bergmann <arnd.bergmann@de.ibm.com>
Signed-off-by: Stephen Hemminger <shemminger@osdl.org>

1 files changed, 1 insertions, 9 deletions

diff --git a/drivers/net/spider_net.c b/drivers/net/spider_net.c
index b36838bfb8dc..394339d5e87c 100644
--- a/drivers/net/spider_net.c
+++ b/drivers/net/spider_net.c
@@ -1794,15 +1794,7 @@ spider_net_setup_phy(struct spider_net_card *card)
         if (phy->def->ops->setup_forced)
                 phy->def->ops->setup_forced(phy, SPEED_1000, DUPLEX_FULL);
 
-        /* the following two writes could be moved to sungem_phy.c */
-        /* enable fiber mode */
-        spider_net_write_phy(card->netdev, 1, MII_NCONFIG, 0x9020);
-        /* LEDs active in both modes, autosense prio = fiber */
-        spider_net_write_phy(card->netdev, 1, MII_NCONFIG, 0x945f);
-
-        /* switch off fibre autoneg */
-        spider_net_write_phy(card->netdev, 1, MII_NCONFIG, 0xfc01);
-        spider_net_write_phy(card->netdev, 1, 0x0b, 0x0004);
+        phy->def->ops->enable_fiber(phy);
 
         phy->def->ops->read_link(phy);
         pr_info("Found %s with %i Mbps, %s-duplex.\n", phy->def->name,