diff options
author | Linus Torvalds <torvalds@linux-foundation.org> | 2009-01-31 18:50:43 -0500 |
---|---|---|
committer | Linus Torvalds <torvalds@linux-foundation.org> | 2009-01-31 18:50:43 -0500 |
commit | f984d024190d5df98e448e35aa9e89a46fe50bb9 (patch) | |
tree | 7443594ff0a55bf0bc49fbcd90d1ec3334a4cb05 /drivers/net/sfc/sfe4001.c | |
parent | fc8744adc870a8d4366908221508bb113d8b72ee (diff) | |
parent | 5d0932a5dd00d83df5d1e15eeffb6edf015a8579 (diff) |
Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-2.6
* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-2.6:
igb: fix link reporting when using sgmii
igb: prevent skb_over panic w/ mtu smaller than 1K
igb: Fix DCA errors and do not use context index for 82576
ipv6: compile fix for ip6mr.c
packet: Avoid lock_sock in mmap handler
sfc: Replace stats_enabled flag with a disable count
sfc: SFX7101/SFT9001: Fix AN advertisements
sfc: SFT9001: Always enable XNP exchange on SFT9001 rev B
sfc: Update board info for hardware monitor on SFN4111T-R5 and later
sfc: Test for PHYXS faults whenever we cannot test link state bits
sfc: Reinitialise the PHY completely in case of a PHY or NIC reset
sfc: Fix post-reset MAC selection
sfc: SFN4111T: Fix GPIO sharing between I2C and FLASH_CFG_1
sfc: SFT9001: Fix speed reporting in 1G PHY loopback
sfc: SFX7101: Remove workaround for bad link training
sfc: SFT9001: Enable robust link training
sky2: fix hard hang with netconsoling and iface going up
Diffstat (limited to 'drivers/net/sfc/sfe4001.c')
-rw-r--r-- | drivers/net/sfc/sfe4001.c | 42 |
1 files changed, 33 insertions, 9 deletions
diff --git a/drivers/net/sfc/sfe4001.c b/drivers/net/sfc/sfe4001.c index 16b80acb9992..cb25ae5b257a 100644 --- a/drivers/net/sfc/sfe4001.c +++ b/drivers/net/sfc/sfe4001.c | |||
@@ -186,19 +186,22 @@ static int sfn4111t_reset(struct efx_nic *efx) | |||
186 | { | 186 | { |
187 | efx_oword_t reg; | 187 | efx_oword_t reg; |
188 | 188 | ||
189 | /* GPIO pins are also used for I2C, so block that temporarily */ | 189 | /* GPIO 3 and the GPIO register are shared with I2C, so block that */ |
190 | mutex_lock(&efx->i2c_adap.bus_lock); | 190 | mutex_lock(&efx->i2c_adap.bus_lock); |
191 | 191 | ||
192 | /* Pull RST_N (GPIO 2) low then let it up again, setting the | ||
193 | * FLASH_CFG_1 strap (GPIO 3) appropriately. Only change the | ||
194 | * output enables; the output levels should always be 0 (low) | ||
195 | * and we rely on external pull-ups. */ | ||
192 | falcon_read(efx, ®, GPIO_CTL_REG_KER); | 196 | falcon_read(efx, ®, GPIO_CTL_REG_KER); |
193 | EFX_SET_OWORD_FIELD(reg, GPIO2_OEN, true); | 197 | EFX_SET_OWORD_FIELD(reg, GPIO2_OEN, true); |
194 | EFX_SET_OWORD_FIELD(reg, GPIO2_OUT, false); | ||
195 | falcon_write(efx, ®, GPIO_CTL_REG_KER); | 198 | falcon_write(efx, ®, GPIO_CTL_REG_KER); |
196 | msleep(1000); | 199 | msleep(1000); |
197 | EFX_SET_OWORD_FIELD(reg, GPIO2_OUT, true); | 200 | EFX_SET_OWORD_FIELD(reg, GPIO2_OEN, false); |
198 | EFX_SET_OWORD_FIELD(reg, GPIO3_OEN, true); | 201 | EFX_SET_OWORD_FIELD(reg, GPIO3_OEN, |
199 | EFX_SET_OWORD_FIELD(reg, GPIO3_OUT, | 202 | !!(efx->phy_mode & PHY_MODE_SPECIAL)); |
200 | !(efx->phy_mode & PHY_MODE_SPECIAL)); | ||
201 | falcon_write(efx, ®, GPIO_CTL_REG_KER); | 203 | falcon_write(efx, ®, GPIO_CTL_REG_KER); |
204 | msleep(1); | ||
202 | 205 | ||
203 | mutex_unlock(&efx->i2c_adap.bus_lock); | 206 | mutex_unlock(&efx->i2c_adap.bus_lock); |
204 | 207 | ||
@@ -232,12 +235,18 @@ static ssize_t set_phy_flash_cfg(struct device *dev, | |||
232 | } else if (efx->state != STATE_RUNNING || netif_running(efx->net_dev)) { | 235 | } else if (efx->state != STATE_RUNNING || netif_running(efx->net_dev)) { |
233 | err = -EBUSY; | 236 | err = -EBUSY; |
234 | } else { | 237 | } else { |
238 | /* Reset the PHY, reconfigure the MAC and enable/disable | ||
239 | * MAC stats accordingly. */ | ||
235 | efx->phy_mode = new_mode; | 240 | efx->phy_mode = new_mode; |
241 | if (new_mode & PHY_MODE_SPECIAL) | ||
242 | efx_stats_disable(efx); | ||
236 | if (efx->board_info.type == EFX_BOARD_SFE4001) | 243 | if (efx->board_info.type == EFX_BOARD_SFE4001) |
237 | err = sfe4001_poweron(efx); | 244 | err = sfe4001_poweron(efx); |
238 | else | 245 | else |
239 | err = sfn4111t_reset(efx); | 246 | err = sfn4111t_reset(efx); |
240 | efx_reconfigure_port(efx); | 247 | efx_reconfigure_port(efx); |
248 | if (!(new_mode & PHY_MODE_SPECIAL)) | ||
249 | efx_stats_enable(efx); | ||
241 | } | 250 | } |
242 | rtnl_unlock(); | 251 | rtnl_unlock(); |
243 | 252 | ||
@@ -326,6 +335,11 @@ int sfe4001_init(struct efx_nic *efx) | |||
326 | efx->board_info.monitor = sfe4001_check_hw; | 335 | efx->board_info.monitor = sfe4001_check_hw; |
327 | efx->board_info.fini = sfe4001_fini; | 336 | efx->board_info.fini = sfe4001_fini; |
328 | 337 | ||
338 | if (efx->phy_mode & PHY_MODE_SPECIAL) { | ||
339 | /* PHY won't generate a 156.25 MHz clock and MAC stats fetch | ||
340 | * will fail. */ | ||
341 | efx_stats_disable(efx); | ||
342 | } | ||
329 | rc = sfe4001_poweron(efx); | 343 | rc = sfe4001_poweron(efx); |
330 | if (rc) | 344 | if (rc) |
331 | goto fail_ioexp; | 345 | goto fail_ioexp; |
@@ -372,17 +386,25 @@ static void sfn4111t_fini(struct efx_nic *efx) | |||
372 | i2c_unregister_device(efx->board_info.hwmon_client); | 386 | i2c_unregister_device(efx->board_info.hwmon_client); |
373 | } | 387 | } |
374 | 388 | ||
375 | static struct i2c_board_info sfn4111t_hwmon_info = { | 389 | static struct i2c_board_info sfn4111t_a0_hwmon_info = { |
376 | I2C_BOARD_INFO("max6647", 0x4e), | 390 | I2C_BOARD_INFO("max6647", 0x4e), |
377 | .irq = -1, | 391 | .irq = -1, |
378 | }; | 392 | }; |
379 | 393 | ||
394 | static struct i2c_board_info sfn4111t_r5_hwmon_info = { | ||
395 | I2C_BOARD_INFO("max6646", 0x4d), | ||
396 | .irq = -1, | ||
397 | }; | ||
398 | |||
380 | int sfn4111t_init(struct efx_nic *efx) | 399 | int sfn4111t_init(struct efx_nic *efx) |
381 | { | 400 | { |
382 | int rc; | 401 | int rc; |
383 | 402 | ||
384 | efx->board_info.hwmon_client = | 403 | efx->board_info.hwmon_client = |
385 | i2c_new_device(&efx->i2c_adap, &sfn4111t_hwmon_info); | 404 | i2c_new_device(&efx->i2c_adap, |
405 | (efx->board_info.minor < 5) ? | ||
406 | &sfn4111t_a0_hwmon_info : | ||
407 | &sfn4111t_r5_hwmon_info); | ||
386 | if (!efx->board_info.hwmon_client) | 408 | if (!efx->board_info.hwmon_client) |
387 | return -EIO; | 409 | return -EIO; |
388 | 410 | ||
@@ -394,8 +416,10 @@ int sfn4111t_init(struct efx_nic *efx) | |||
394 | if (rc) | 416 | if (rc) |
395 | goto fail_hwmon; | 417 | goto fail_hwmon; |
396 | 418 | ||
397 | if (efx->phy_mode & PHY_MODE_SPECIAL) | 419 | if (efx->phy_mode & PHY_MODE_SPECIAL) { |
420 | efx_stats_disable(efx); | ||
398 | sfn4111t_reset(efx); | 421 | sfn4111t_reset(efx); |
422 | } | ||
399 | 423 | ||
400 | return 0; | 424 | return 0; |
401 | 425 | ||