e1000e: comment corrections

Signed-off-by: Bruce Allan <bruce.w.allan@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

1 files changed, 7 insertions, 7 deletions

diff --git a/drivers/net/e1000e/phy.c b/drivers/net/e1000e/phy.c
index 140b23b320fd..1bc09b240e62 100644
--- a/drivers/net/e1000e/phy.c
+++ b/drivers/net/e1000e/phy.c
@@ -153,10 +153,10 @@ s32 e1000e_get_phy_id(struct e1000_hw *hw)
                         goto out;
 
                 /*
-                 * If the PHY ID is still unknown, we may have an 82577i
-                 * without link.  We will try again after setting Slow
-                 * MDIC mode. No harm in trying again in this case since
-                 * the PHY ID is unknown at this point anyway
+                 * If the PHY ID is still unknown, we may have an 82577
+                 * without link.  We will try again after setting Slow MDIC
+                 * mode. No harm in trying again in this case since the PHY
+                 * ID is unknown at this point anyway.
                  */
                 ret_val = phy->ops.acquire(hw);
                 if (ret_val)
@@ -1744,7 +1744,7 @@ out:
  *  The automatic gain control (agc) normalizes the amplitude of the
  *  received signal, adjusting for the attenuation produced by the
  *  cable.  By reading the AGC registers, which represent the
- *  combination of course and fine gain value, the value can be put
+ *  combination of coarse and fine gain value, the value can be put
  *  into a lookup table to obtain the approximate cable length
  *  for each channel.
  **/
@@ -1769,7 +1769,7 @@ s32 e1000e_get_cable_length_igp_2(struct e1000_hw *hw)
 
                 /*
                  * Getting bits 15:9, which represent the combination of
-                 * course and fine gain values.  The result is a number
+                 * coarse and fine gain values.  The result is a number
                  * that can be put into the lookup table to obtain the
                  * approximate cable length.
                  */
@@ -2511,7 +2511,7 @@ static s32 e1000_access_phy_wakeup_reg_bm(struct e1000_hw *hw, u32 offset,
                 ret_val = e1000e_read_phy_reg_mdic(hw, BM_WUC_DATA_OPCODE,
                                                    data);
         } else {
-                /* Read the page 800 value using opcode 0x12 */
+                /* Write the page 800 value using opcode 0x12 */
                 ret_val = e1000e_write_phy_reg_mdic(hw, BM_WUC_DATA_OPCODE,
                                                     *data);
         }