mtd: NOR flash driver for OMAP-L137/AM17x

OMAP-L137/AM17x has limited number of dedicated EMIFA
address pins, enough to interface directly to an SDRAM.
If a device such as an asynchronous flash needs to be
attached to the EMIFA, then either GPIO pins or a chip
select may be used to control the flash device's upper
address lines.

This patch adds support for the NOR flash on the OMAP-L137/
AM17x user interface daughter board using the latch-addr-flash
MTD mapping driver which allows flashes to be partially
physically addressed. The upper address lines are set by
a board specific code which is a separate patch.

Signed-off-by: David Griego <dgriego@mvista.com>
Signed-off-by: Aleksey Makarov <amakarov@ru.mvista.com>
Signed-off-by: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: Savinay Dharmappa <savinay.dharmappa@ti.com>
Signed-off-by: Artem Bityutskiy <Artem.Bityutskiy@nokia.com>
Signed-off-by: David Woodhouse <David.Woodhouse@intel.com>

1 files changed, 9 insertions, 0 deletions

diff --git a/drivers/mtd/maps/Kconfig b/drivers/mtd/maps/Kconfig
index 803072a71ed7..44b1f46458ca 100644
--- a/drivers/mtd/maps/Kconfig
+++ b/drivers/mtd/maps/Kconfig
@@ -552,4 +552,13 @@ config MTD_PISMO
 
           When built as a module, it will be called pismo.ko
 
+config MTD_LATCH_ADDR
+        tristate "Latch-assisted Flash Chip Support"
+        depends on MTD_COMPLEX_MAPPINGS
+        help
+          Map driver which allows flashes to be partially physically addressed
+          and have the upper address lines set by a board specific code.
+
+          If compiled as a module, it will be called latch-addr-flash.
+
 endmenu