md: improve partition detection in md array

md currently uses ->media_changed to make sure rescan_partitions
is call on md array after they are assembled.

However that doesn't happen until the array is opened, which is later
than some people would like.

So use blkdev_ioctl to do the rescan immediately that the
array has been assembled.

This means we can remove all the ->change infrastructure as it was only used
to trigger a partition rescan.

Signed-off-by: Neil Brown <neilb@suse.de>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

1 files changed, 0 insertions, 2 deletions

diff --git a/drivers/md/raid5.c b/drivers/md/raid5.c
index 061375ee6592..a72e70ad0975 100644
--- a/drivers/md/raid5.c
+++ b/drivers/md/raid5.c
@@ -3864,7 +3864,6 @@ static int raid5_resize(mddev_t *mddev, sector_t sectors)
         sectors &= ~((sector_t)mddev->chunk_size/512 - 1);
         mddev->array_size = (sectors * (mddev->raid_disks-conf->max_degraded))>>1;
         set_capacity(mddev->gendisk, mddev->array_size << 1);
-        mddev->changed = 1;
         if (sectors/2  > mddev->size && mddev->recovery_cp == MaxSector) {
                 mddev->recovery_cp = mddev->size << 1;
                 set_bit(MD_RECOVERY_NEEDED, &mddev->recovery);
@@ -3999,7 +3998,6 @@ static void end_reshape(raid5_conf_t *conf)
                 conf->mddev->array_size = conf->mddev->size *
                         (conf->raid_disks - conf->max_degraded);
                 set_capacity(conf->mddev->gendisk, conf->mddev->array_size << 1);
-                conf->mddev->changed = 1;
 
                 bdev = bdget_disk(conf->mddev->gendisk, 0);
                 if (bdev) {