[Bluetooth] Add ignore parameters to the HCI USB driver

This patch adds the module parameters ignore_csr and ignore_sniffer
to the HCI USB driver. This allows an easier use of CSR ROM chips
that need an additional initialization routine and the Frontline
sniffers.

Signed-off-by: Marcel Holtmann <marcel@holtmann.org>

1 files changed, 18 insertions, 1 deletions

diff --git a/drivers/bluetooth/hci_usb.c b/drivers/bluetooth/hci_usb.c
index 67d96b5cbb96..57c48bbf6fe6 100644
--- a/drivers/bluetooth/hci_usb.c
+++ b/drivers/bluetooth/hci_usb.c
@@ -65,13 +65,15 @@
 #endif
 
 static int ignore = 0;
+static int ignore_csr = 0;
+static int ignore_sniffer = 0;
 static int reset = 0;
 
 #ifdef CONFIG_BT_HCIUSB_SCO
 static int isoc = 2;
 #endif
 
-#define VERSION "2.8"
+#define VERSION "2.9"
 
 static struct usb_driver hci_usb_driver; 
 
@@ -98,6 +100,9 @@ static struct usb_device_id bluetooth_ids[] = {
 MODULE_DEVICE_TABLE (usb, bluetooth_ids);
 
 static struct usb_device_id blacklist_ids[] = {
+        /* CSR BlueCore devices */
+        { USB_DEVICE(0x0a12, 0x0001), .driver_info = HCI_CSR },
+
         /* Broadcom BCM2033 without firmware */
         { USB_DEVICE(0x0a5c, 0x2033), .driver_info = HCI_IGNORE },
 
@@ -836,6 +841,12 @@ static int hci_usb_probe(struct usb_interface *intf, const struct usb_device_id
         if (ignore || id->driver_info & HCI_IGNORE)
                 return -ENODEV;
 
+        if (ignore_csr && id->driver_info & HCI_CSR)
+                return -ENODEV;
+
+        if (ignore_sniffer && id->driver_info & HCI_SNIFFER)
+                return -ENODEV;
+
         if (intf->cur_altsetting->desc.bInterfaceNumber > 0)
                 return -ENODEV;
 
@@ -1061,6 +1072,12 @@ module_exit(hci_usb_exit);
 module_param(ignore, bool, 0644);
 MODULE_PARM_DESC(ignore, "Ignore devices from the matching table");
 
+module_param(ignore_csr, bool, 0644);
+MODULE_PARM_DESC(ignore_csr, "Ignore devices with id 0a12:0001");
+
+module_param(ignore_sniffer, bool, 0644);
+MODULE_PARM_DESC(ignore_sniffer, "Ignore devices with id 0a12:0002");
+
 module_param(reset, bool, 0644);
 MODULE_PARM_DESC(reset, "Send HCI reset command on initialization");