[libata #pata-drivers] Trim trailing whitespace.

1 files changed, 8 insertions, 8 deletions

diff --git a/drivers/ata/pata_radisys.c b/drivers/ata/pata_radisys.c
index 6f7d0527265f..277f8411b521 100644
--- a/drivers/ata/pata_radisys.c
+++ b/drivers/ata/pata_radisys.c
@@ -32,7 +32,7 @@
  *
  *      Set up cable type and use generic probe init
  */
- 
+
 static int radisys_pre_reset(struct ata_port *ap)
 {
         ap->cbl = ATA_CBL_PATA80;
@@ -122,7 +122,7 @@ static void radisys_set_dmamode (struct ata_port *ap, struct ata_device *adev)
         struct pci_dev *dev     = to_pci_dev(ap->host->dev);
         u16 idetm_data;
         u8 udma_enable;
-        
+
         static const     /* ISP  RTC */
         u8 timings[][2] = { { 0, 0 },
                             { 0, 0 },
@@ -154,7 +154,7 @@ static void radisys_set_dmamode (struct ata_port *ap, struct ata_device *adev)
 
                 /* Mask out the relevant control and timing bits we will load. Also
                    clear the other drive TIME register as a precaution */
-                   
+
                 idetm_data &= 0xCCCC;
                 idetm_data |= control << (4 * adev->devno);
                 idetm_data |= (timings[pio][0] << 12) | (timings[pio][1] << 8);
@@ -162,18 +162,18 @@ static void radisys_set_dmamode (struct ata_port *ap, struct ata_device *adev)
                 udma_enable &= ~(1 << adev->devno);
         } else {
                 u8 udma_mode;
-                
+
                 /* UDMA66 on: UDMA 33 and 66 are switchable via register 0x4A */
-                
+
                 pci_read_config_byte(dev, 0x4A, &udma_mode);
-                
+
                 if (adev->xfer_mode == XFER_UDMA_2)
                         udma_mode &= ~ (1 << adev->devno);
                 else /* UDMA 4 */
                         udma_mode |= (1 << adev->devno);
-                        
+
                 pci_write_config_byte(dev, 0x4A, udma_mode);
-                
+
                 udma_enable |= (1 << adev->devno);
         }
         pci_write_config_word(dev, 0x40, idetm_data);