libata: kill ata_id_to_dma_mode()

ata_id_to_dma_mode() isn't quite generic.  The function is basically
privately implemented ata_id_xfermask() combined with hardcoded mode
printing and configuration which are specific to ata_generic.

Kill the function and open code it in generic_set_mode() using generic
xfermode handling functions.

Signed-off-by: Tejun Heo <htejun@gmail.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>

1 files changed, 0 insertions, 43 deletions

diff --git a/drivers/ata/libata-core.c b/drivers/ata/libata-core.c
index a70ed7b3bc55..ab84772235c9 100644
--- a/drivers/ata/libata-core.c
+++ b/drivers/ata/libata-core.c
@@ -1288,48 +1288,6 @@ static int ata_hpa_resize(struct ata_device *dev)
 }
 
 /**
- *      ata_id_to_dma_mode      -       Identify DMA mode from id block
- *      @dev: device to identify
- *      @unknown: mode to assume if we cannot tell
- *
- *      Set up the timing values for the device based upon the identify
- *      reported values for the DMA mode. This function is used by drivers
- *      which rely upon firmware configured modes, but wish to report the
- *      mode correctly when possible.
- *
- *      In addition we emit similarly formatted messages to the default
- *      ata_dev_set_mode handler, in order to provide consistency of
- *      presentation.
- */
-
-void ata_id_to_dma_mode(struct ata_device *dev, u8 unknown)
-{
-        unsigned int mask;
-        u8 mode;
-
-        /* Pack the DMA modes */
-        mask = ((dev->id[63] >> 8) << ATA_SHIFT_MWDMA) & ATA_MASK_MWDMA;
-        if (dev->id[53] & 0x04)
-                mask |= ((dev->id[88] >> 8) << ATA_SHIFT_UDMA) & ATA_MASK_UDMA;
-
-        /* Select the mode in use */
-        mode = ata_xfer_mask2mode(mask);
-
-        if (mode != 0xff) {
-                ata_dev_printk(dev, KERN_INFO, "configured for %s\n",
-                       ata_mode_string(mask));
-        } else {
-                /* SWDMA perhaps ? */
-                mode = unknown;
-                ata_dev_printk(dev, KERN_INFO, "configured for DMA\n");
-        }
-
-        /* Configure the device reporting */
-        dev->xfer_mode = mode;
-        dev->xfer_shift = ata_xfer_mode2shift(mode);
-}
-
-/**
  *      ata_noop_dev_select - Select device 0/1 on ATA bus
  *      @ap: ATA channel to manipulate
  *      @device: ATA device (numbered from zero) to select
@@ -7653,7 +7611,6 @@ EXPORT_SYMBOL_GPL(ata_host_resume);
 #endif /* CONFIG_PM */
 EXPORT_SYMBOL_GPL(ata_id_string);
 EXPORT_SYMBOL_GPL(ata_id_c_string);
-EXPORT_SYMBOL_GPL(ata_id_to_dma_mode);
 EXPORT_SYMBOL_GPL(ata_scsi_simulate);
 
 EXPORT_SYMBOL_GPL(ata_pio_need_iordy);