[POWERPC] bootwrapper: Add TARGET_HAS_ETHn tests to ppcboot.h

U-boots more recent than when ppcboot.h was forked allow the board config
file to enable additional ethernet ports explicitly, rather than
using a hardcoded list of targets.  This allows bootwrapper platform
files to do the same.

Fortunately, nothing after the ethernet addresses is of interest to
cuboot platforms, so the inevitable mismatches won't be too catastrophic.

Signed-off-by: Scott Wood <scottwood@freescale.com>
Acked-by: David Gibson <david@gibson.dropbear.id.au>
Signed-off-by: Paul Mackerras <paulus@samba.org>

1 files changed, 4 insertions, 3 deletions

diff --git a/arch/powerpc/boot/ppcboot.h b/arch/powerpc/boot/ppcboot.h
index 5290ff2c2b2b..6ae6f9063952 100644
--- a/arch/powerpc/boot/ppcboot.h
+++ b/arch/powerpc/boot/ppcboot.h
@@ -78,17 +78,18 @@ typedef struct bd_info {
         hymod_conf_t    bi_hymod_conf;  /* hymod configuration information */
 #endif
 #if defined(TARGET_EVB64260) || defined(TARGET_405EP) || defined(TARGET_44x) || \
-        defined(TARGET_85xx) || defined(TARGET_83xx)
+        defined(TARGET_85xx) || defined(TARGET_83xx) || defined(TARGET_HAS_ETH1)
         /* second onboard ethernet port */
         unsigned char   bi_enet1addr[6];
 #define HAVE_ENET1ADDR
 #endif
-#if defined(TARGET_EVB64260) || defined(TARGET_440GX) || defined(TARGET_85xx)
+#if defined(TARGET_EVB64260) || defined(TARGET_440GX) || \
+    defined(TARGET_85xx) || defined(TARGET_HAS_ETH2)
         /* third onboard ethernet ports */
         unsigned char   bi_enet2addr[6];
 #define HAVE_ENET2ADDR
 #endif
-#if defined(TARGET_440GX)
+#if defined(TARGET_440GX) || defined(TARGET_HAS_ETH3)
         /* fourth onboard ethernet ports */
         unsigned char   bi_enet3addr[6];
 #define HAVE_ENET3ADDR