x86: convert Dprintk to pr_debug

There are a couple of places where (P)Dprintk is used which is an old
compile time enabled printk wrapper. Convert it to the generic
pr_debug().

Signed-off-by: Thomas Gleixner <tglx@linutronix.de>

1 files changed, 3 insertions, 3 deletions

diff --git a/arch/x86/kernel/acpi/boot.c b/arch/x86/kernel/acpi/boot.c
index f489d7a9be92..fa88a1d71290 100644
--- a/arch/x86/kernel/acpi/boot.c
+++ b/arch/x86/kernel/acpi/boot.c
@@ -1021,7 +1021,7 @@ void __init mp_config_acpi_legacy_irqs(void)
         mp_bus_id_to_type[MP_ISA_BUS] = MP_BUS_ISA;
 #endif
         set_bit(MP_ISA_BUS, mp_bus_not_pci);
-        Dprintk("Bus #%d is ISA\n", MP_ISA_BUS);
+        pr_debug("Bus #%d is ISA\n", MP_ISA_BUS);
 
 #ifdef CONFIG_X86_ES7000
         /*
@@ -1127,8 +1127,8 @@ int mp_register_gsi(u32 gsi, int triggering, int polarity)
                 return gsi;
         }
         if (test_bit(ioapic_pin, mp_ioapic_routing[ioapic].pin_programmed)) {
-                Dprintk(KERN_DEBUG "Pin %d-%d already programmed\n",
-                        mp_ioapic_routing[ioapic].apic_id, ioapic_pin);
+                pr_debug(KERN_DEBUG "Pin %d-%d already programmed\n",
+                         mp_ioapic_routing[ioapic].apic_id, ioapic_pin);
 #ifdef CONFIG_X86_32
                 return (gsi < IRQ_COMPRESSION_START ? gsi : gsi_to_irq[gsi]);
 #else