powerpc: Move include files to arch/powerpc/include/asm

from include/asm-powerpc.  This is the result of a

mkdir arch/powerpc/include/asm
git mv include/asm-powerpc/* arch/powerpc/include/asm

Followed by a few documentation/comment fixups and a couple of places
where <asm-powepc/...> was being used explicitly.  Of the latter only
one was outside the arch code and it is a driver only built for powerpc.

Signed-off-by: Stephen Rothwell <sfr@canb.auug.org.au>
Signed-off-by: Paul Mackerras <paulus@samba.org>

1 files changed, 108 insertions, 0 deletions

diff --git a/arch/powerpc/include/asm/dbdma.h b/arch/powerpc/include/asm/dbdma.h
new file mode 100644
index 000000000000..e23f07e73cb3
--- /dev/null
+++ b/arch/powerpc/include/asm/dbdma.h
@@ -0,0 +1,108 @@
+/*
+ * Definitions for using the Apple Descriptor-Based DMA controller
+ * in Power Macintosh computers.
+ *
+ * Copyright (C) 1996 Paul Mackerras.
+ */
+
+#ifdef __KERNEL__
+#ifndef _ASM_DBDMA_H_
+#define _ASM_DBDMA_H_
+/*
+ * DBDMA control/status registers.  All little-endian.
+ */
+struct dbdma_regs {
+    unsigned int control;       /* lets you change bits in status */
+    unsigned int status;        /* DMA and device status bits (see below) */
+    unsigned int cmdptr_hi;     /* upper 32 bits of command address */
+    unsigned int cmdptr;        /* (lower 32 bits of) command address (phys) */
+    unsigned int intr_sel;      /* select interrupt condition bit */
+    unsigned int br_sel;        /* select branch condition bit */
+    unsigned int wait_sel;      /* select wait condition bit */
+    unsigned int xfer_mode;
+    unsigned int data2ptr_hi;
+    unsigned int data2ptr;
+    unsigned int res1;
+    unsigned int address_hi;
+    unsigned int br_addr_hi;
+    unsigned int res2[3];
+};
+
+/* Bits in control and status registers */
+#define RUN     0x8000
+#define PAUSE   0x4000
+#define FLUSH   0x2000
+#define WAKE    0x1000
+#define DEAD    0x0800
+#define ACTIVE  0x0400
+#define BT      0x0100
+#define DEVSTAT 0x00ff
+
+/*
+ * DBDMA command structure.  These fields are all little-endian!
+ */
+struct dbdma_cmd {
+    unsigned short req_count;   /* requested byte transfer count */
+    unsigned short command;     /* command word (has bit-fields) */
+    unsigned int   phy_addr;    /* physical data address */
+    unsigned int   cmd_dep;     /* command-dependent field */
+    unsigned short res_count;   /* residual count after completion */
+    unsigned short xfer_status; /* transfer status */
+};
+
+/* DBDMA command values in command field */
+#define OUTPUT_MORE     0       /* transfer memory data to stream */
+#define OUTPUT_LAST     0x1000  /* ditto followed by end marker */
+#define INPUT_MORE      0x2000  /* transfer stream data to memory */
+#define INPUT_LAST      0x3000  /* ditto, expect end marker */
+#define STORE_WORD      0x4000  /* write word (4 bytes) to device reg */
+#define LOAD_WORD       0x5000  /* read word (4 bytes) from device reg */
+#define DBDMA_NOP       0x6000  /* do nothing */
+#define DBDMA_STOP      0x7000  /* suspend processing */
+
+/* Key values in command field */
+#define KEY_STREAM0     0       /* usual data stream */
+#define KEY_STREAM1     0x100   /* control/status stream */
+#define KEY_STREAM2     0x200   /* device-dependent stream */
+#define KEY_STREAM3     0x300   /* device-dependent stream */
+#define KEY_REGS        0x500   /* device register space */
+#define KEY_SYSTEM      0x600   /* system memory-mapped space */
+#define KEY_DEVICE      0x700   /* device memory-mapped space */
+
+/* Interrupt control values in command field */
+#define INTR_NEVER      0       /* don't interrupt */
+#define INTR_IFSET      0x10    /* intr if condition bit is 1 */
+#define INTR_IFCLR      0x20    /* intr if condition bit is 0 */
+#define INTR_ALWAYS     0x30    /* always interrupt */
+
+/* Branch control values in command field */
+#define BR_NEVER        0       /* don't branch */
+#define BR_IFSET        0x4     /* branch if condition bit is 1 */
+#define BR_IFCLR        0x8     /* branch if condition bit is 0 */
+#define BR_ALWAYS       0xc     /* always branch */
+
+/* Wait control values in command field */
+#define WAIT_NEVER      0       /* don't wait */
+#define WAIT_IFSET      1       /* wait if condition bit is 1 */
+#define WAIT_IFCLR      2       /* wait if condition bit is 0 */
+#define WAIT_ALWAYS     3       /* always wait */
+
+/* Align an address for a DBDMA command structure */
+#define DBDMA_ALIGN(x)  (((unsigned long)(x) + sizeof(struct dbdma_cmd) - 1) \
+                         & -sizeof(struct dbdma_cmd))
+
+/* Useful macros */
+#define DBDMA_DO_STOP(regs) do {                                \
+        out_le32(&((regs)->control), (RUN|FLUSH)<<16);          \
+        while(in_le32(&((regs)->status)) & (ACTIVE|FLUSH))      \
+                ; \
+} while(0)
+
+#define DBDMA_DO_RESET(regs) do {                               \
+        out_le32(&((regs)->control), (ACTIVE|DEAD|WAKE|FLUSH|PAUSE|RUN)<<16);\
+        while(in_le32(&((regs)->status)) & (RUN)) \
+                ; \
+} while(0)
+
+#endif /* _ASM_DBDMA_H_ */
+#endif /* __KERNEL__ */