Merge branch 'devel' of master.kernel.org:/home/rmk/linux-2.6-arm

* 'devel' of master.kernel.org:/home/rmk/linux-2.6-arm: (130 commits)
  [ARM] 3856/1: Add clocksource for Intel IXP4xx platforms
  [ARM] 3855/1: Add generic time support
  [ARM] 3873/1: S3C24XX: Add irq_chip names
  [ARM] 3872/1: S3C24XX: Apply consistant tabbing to irq_chips
  [ARM] 3871/1: S3C24XX: Fix ordering of EINT4..23
  [ARM] nommu: confirms the CR_V bit in nommu mode
  [ARM] nommu: abort handler fixup for !CPU_CP15_MMU cores.
  [ARM] 3870/1: AT91: Start removing static memory mappings
  [ARM] 3869/1: AT91: NAND support for DK and KB9202 boards
  [ARM] 3868/1: AT91 hardware header update
  [ARM] 3867/1: AT91 GPIO update
  [ARM] 3866/1: AT91 clock update
  [ARM] 3865/1: AT91RM9200 header updates
  [ARM] 3862/2: S3C2410 - add basic power management support for AML M5900 series
  [ARM] kthread: switch arch/arm/kernel/apm.c
  [ARM] Off-by-one in arch/arm/common/icst*
  [ARM] 3864/1: Refactore sharpsl_pm
  [ARM] 3863/1: Add Locomo SPI Device
  [ARM] 3847/2:  Convert LOMOMO to use struct device for GPIOs
  [ARM] Use CPU_CACHE_* where possible in asm/cacheflush.h
  ...

1 files changed, 5 insertions, 2 deletions

diff --git a/arch/arm/mach-omap2/board-apollon.c b/arch/arm/mach-omap2/board-apollon.c
index 7993b7bae2bd..2db6b732b084 100644
--- a/arch/arm/mach-omap2/board-apollon.c
+++ b/arch/arm/mach-omap2/board-apollon.c
@@ -166,8 +166,8 @@ static struct omap_uart_config apollon_uart_config __initdata = {
 
 static struct omap_mmc_config apollon_mmc_config __initdata = {
         .mmc [0] = {
-                .enabled        = 0,
-                .wire4          = 0,
+                .enabled        = 1,
+                .wire4          = 1,
                 .wp_pin         = -1,
                 .power_pin      = -1,
                 .switch_pin     = -1,
@@ -257,6 +257,9 @@ static void __init omap_apollon_init(void)
         /* REVISIT: where's the correct place */
         omap_cfg_reg(W19_24XX_SYS_NIRQ);
 
+        /* Use Interal loop-back in MMC/SDIO Module Input Clock selection */
+        CONTROL_DEVCONF |= (1 << 24);
+
         /*
          * Make sure the serial ports are muxed on at this point.
          * You have to mux them off in device drivers later on