ARM: EXYNOS: Remove remaining dead code after non-DT support removal

This patch removes remaining small bits of unused code that was left
after removing non-DT support.

Signed-off-by: Arnd Bergmann <arnd@arndb.de>
Signed-off-by: Tomasz Figa <t.figa@samsung.com>
Signed-off-by: Kyungmin Park <kyungmin.park@samsung.com>
Signed-off-by: Kukjin Kim <kgene.kim@samsung.com>

1 files changed, 0 insertions, 17 deletions

diff --git a/arch/arm/mach-exynos/Kconfig b/arch/arm/mach-exynos/Kconfig
index 1f356790a4f4..46c8332476f8 100644
--- a/arch/arm/mach-exynos/Kconfig
+++ b/arch/arm/mach-exynos/Kconfig
@@ -115,23 +115,6 @@ config MACH_EXYNOS5_DT
           Machine support for Samsung EXYNOS5 machine with device tree enabled.
           Select this if a fdt blob is available for the EXYNOS5 SoC based board.
 
-if ARCH_EXYNOS4
-
-comment "Configuration for HSMMC 8-bit bus width"
-
-config EXYNOS4_SDHCI_CH0_8BIT
-        bool "Channel 0 with 8-bit bus"
-        help
-          Support HSMMC Channel 0 8-bit bus.
-          If selected, Channel 1 is disabled.
-
-config EXYNOS4_SDHCI_CH2_8BIT
-        bool "Channel 2 with 8-bit bus"
-        help
-          Support HSMMC Channel 2 8-bit bus.
-          If selected, Channel 3 is disabled.
-endif
-
 endmenu
 
 endif