AT91: Change nand buswidth logic to match hardware default configuration

The recently modified nand buswitth configuration is not aligned with
board reality: the double footprint on boards is always populated with 8bits
buswidth nand flashes.
So we have to consider that without particular configuration the 8bits
buswidth is selected by default.
Moreover, the previous logic was always using !board_have_nand_8bit(), we
change it to a simpler: board_have_nand_16bit().

Signed-off-by: Nicolas Ferre <nicolas.ferre@atmel.com>
Tested-by: Ludovic Desroches <ludovic.desroches@atmel.com>
Signed-off-by: Arnd Bergmann <arnd@arndb.de>

1 files changed, 1 insertions, 1 deletions

diff --git a/arch/arm/mach-at91/board-sam9g20ek.c b/arch/arm/mach-at91/board-sam9g20ek.c
index 7624cf0d006b..1325a50101a8 100644
--- a/arch/arm/mach-at91/board-sam9g20ek.c
+++ b/arch/arm/mach-at91/board-sam9g20ek.c
@@ -198,7 +198,7 @@ static struct sam9_smc_config __initdata ek_nand_smc_config = {
 
 static void __init ek_add_device_nand(void)
 {
-        ek_nand_data.bus_width_16 = !board_have_nand_8bit();
+        ek_nand_data.bus_width_16 = board_have_nand_16bit();
         /* setup bus-width (8 or 16) */
         if (ek_nand_data.bus_width_16)
                 ek_nand_smc_config.mode |= AT91_SMC_DBW_16;