ARM: at91: move at91_init_leds to board init

This will also allow to finally move the gpio driver to platform device/driver.

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com>

1 files changed, 3 insertions, 3 deletions

diff --git a/arch/arm/mach-at91/board-rm9200ek.c b/arch/arm/mach-at91/board-rm9200ek.c
index b68726140b6a..78ffc8315f97 100644
--- a/arch/arm/mach-at91/board-rm9200ek.c
+++ b/arch/arm/mach-at91/board-rm9200ek.c
@@ -50,9 +50,6 @@ static void __init ek_init_early(void)
 {
         /* Initialize processor: 18.432 MHz crystal */
         at91_initialize(18432000);
-
-        /* Setup the LEDs */
-        at91_init_leds(AT91_PIN_PB1, AT91_PIN_PB2);
 }
 
 static struct macb_platform_data __initdata ek_eth_data = {
@@ -150,6 +147,9 @@ static struct gpio_led ek_leds[] = {
 
 static void __init ek_board_init(void)
 {
+        /* Setup the LEDs */
+        at91_init_leds(AT91_PIN_PB1, AT91_PIN_PB2);
+
         /* Serial */
         /* DBGU on ttyS0. (Rx & Tx only) */
         at91_register_uart(0, 0, 0);