ARM: at91: do not pin mux the UARTs in init_early

There is no need to pinmux the UART so early in the kernel.
Move it to the board init.

This will also allow to finally move the gpio driver to platform device/driver.

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com>

1 files changed, 10 insertions, 11 deletions

diff --git a/arch/arm/mach-at91/board-eb9200.c b/arch/arm/mach-at91/board-eb9200.c
index a189b9f6d9f4..bd1017297989 100644
--- a/arch/arm/mach-at91/board-eb9200.c
+++ b/arch/arm/mach-at91/board-eb9200.c
@@ -44,17 +44,6 @@ static void __init eb9200_init_early(void)
 {
         /* Initialize processor: 18.432 MHz crystal */
         at91_initialize(18432000);
-
-        /* DBGU on ttyS0. (Rx & Tx only) */
-        at91_register_uart(0, 0, 0);
-
-        /* USART1 on ttyS1. (Rx, Tx, CTS, RTS, DTR, DSR, DCD, RI) */
-        at91_register_uart(AT91RM9200_ID_US1, 1, ATMEL_UART_CTS | ATMEL_UART_RTS
-                        | ATMEL_UART_DTR | ATMEL_UART_DSR | ATMEL_UART_DCD
-                        | ATMEL_UART_RI);
-
-        /* USART2 on ttyS2. (Rx, Tx) - IRDA */
-        at91_register_uart(AT91RM9200_ID_US2, 2, 0);
 }
 
 static struct macb_platform_data __initdata eb9200_eth_data = {
@@ -98,6 +87,16 @@ static struct i2c_board_info __initdata eb9200_i2c_devices[] = {
 static void __init eb9200_board_init(void)
 {
         /* Serial */
+        /* DBGU on ttyS0. (Rx & Tx only) */
+        at91_register_uart(0, 0, 0);
+
+        /* USART1 on ttyS1. (Rx, Tx, CTS, RTS, DTR, DSR, DCD, RI) */
+        at91_register_uart(AT91RM9200_ID_US1, 1, ATMEL_UART_CTS | ATMEL_UART_RTS
+                        | ATMEL_UART_DTR | ATMEL_UART_DSR | ATMEL_UART_DCD
+                        | ATMEL_UART_RI);
+
+        /* USART2 on ttyS2. (Rx, Tx) - IRDA */
+        at91_register_uart(AT91RM9200_ID_US2, 2, 0);
         at91_add_device_serial();
         /* Ethernet */
         at91_add_device_eth(&eb9200_eth_data);