ARM: at91: dt: switch to standard GPIO flag defines.

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Signed-off-by: Nicolas Ferre <nicolas.ferre@atmel.com>

1 files changed, 7 insertions, 7 deletions

diff --git a/arch/arm/boot/dts/pm9g45.dts b/arch/arm/boot/dts/pm9g45.dts
index 639410b5de6a..315d9279c9b6 100644
--- a/arch/arm/boot/dts/pm9g45.dts
+++ b/arch/arm/boot/dts/pm9g45.dts
@@ -64,7 +64,7 @@
                                 slot@0 {
                                         reg = <0>;
                                         bus-width = <4>;
-                                        cd-gpios = <&pioD 6 0>;
+                                        cd-gpios = <&pioD 6 GPIO_ACTIVE_HIGH>;
                                 };
                         };
 
@@ -81,8 +81,8 @@
                         nand-on-flash-bbt;
                         pinctrl-0 = <&pinctrl_board_nand>;
 
-                        gpios = <&pioD 3 0
-                                 &pioC 14 0
+                        gpios = <&pioD 3 GPIO_ACTIVE_HIGH
+                                 &pioC 14 GPIO_ACTIVE_HIGH
                                  0
                                 >;
 
@@ -134,13 +134,13 @@
 
                 led0 {
                         label = "led0";
-                        gpios = <&pioD 0 1>;
+                        gpios = <&pioD 0 GPIO_ACTIVE_LOW>;
                         linux,default-trigger = "nand-disk";
                 };
 
                 led1 {
                         label = "led1";
-                        gpios = <&pioD 31 0>;
+                        gpios = <&pioD 31 GPIO_ACTIVE_HIGH>;
                         linux,default-trigger = "heartbeat";
                 };
         };
@@ -152,13 +152,13 @@
 
                 right {
                         label = "SW4";
-                        gpios = <&pioE 7 1>;
+                        gpios = <&pioE 7 GPIO_ACTIVE_LOW>;
                         linux,code = <106>;
                 };
 
                 up {
                         label = "SW3";
-                        gpios = <&pioE 8 1>;
+                        gpios = <&pioE 8 GPIO_ACTIVE_LOW>;
                         linux,code = <103>;
                 };
         };