Documentation: kernel-parameters.txt cleanups

General cleanups to kernel-parameters.txt:
 - add missing $ARCH that are being used/referenced
 - alphabetize the parameter restrictions list
 - spell "IA-64" as listed in arch/ia64/Kconfig instead of "IA64"
 - remove trailing whitespace
 - use hyphen in 32-bit etc.

Signed-off-by: Randy Dunlap <rdunlap@xenotime.net>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

1 files changed, 22 insertions, 20 deletions

diff --git a/Documentation/kernel-parameters.txt b/Documentation/kernel-parameters.txt
index 246b132dcc90..6ca1f5cb71e0 100644
--- a/Documentation/kernel-parameters.txt
+++ b/Documentation/kernel-parameters.txt
@@ -40,6 +40,7 @@ parameter is applicable:
         ALSA    ALSA sound support is enabled.
         APIC    APIC support is enabled.
         APM     Advanced Power Management support is enabled.
+        ARM     ARM architecture is enabled.
         AVR32   AVR32 architecture is enabled.
         AX25    Appropriate AX.25 support is enabled.
         BLACKFIN Blackfin architecture is enabled.
@@ -49,6 +50,7 @@ parameter is applicable:
         EFI     EFI Partitioning (GPT) is enabled
         EIDE    EIDE/ATAPI support is enabled.
         FB      The frame buffer device is enabled.
+        FTRACE  Function tracing enabled.
         GCOV    GCOV profiling is enabled.
         HW      Appropriate hardware is enabled.
         IA-64   IA-64 architecture is enabled.
@@ -69,6 +71,7 @@ parameter is applicable:
                         Documentation/m68k/kernel-options.txt.
         MCA     MCA bus support is enabled.
         MDA     MDA console support is enabled.
+        MIPS    MIPS architecture is enabled.
         MOUSE   Appropriate mouse support is enabled.
         MSI     Message Signaled Interrupts (PCI).
         MTD     MTD (Memory Technology Device) support is enabled.
@@ -100,7 +103,6 @@ parameter is applicable:
         SPARC   Sparc architecture is enabled.
         SWSUSP  Software suspend (hibernation) is enabled.
         SUSPEND System suspend states are enabled.
-        FTRACE  Function tracing enabled.
         TPM     TPM drivers are enabled.
         TS      Appropriate touchscreen support is enabled.
         UMS     USB Mass Storage support is enabled.
@@ -115,7 +117,7 @@ parameter is applicable:
         X86-64  X86-64 architecture is enabled.
                         More X86-64 boot options can be found in
                         Documentation/x86/x86_64/boot-options.txt .
-        X86     Either 32bit or 64bit x86 (same as X86-32+X86-64)
+        X86     Either 32-bit or 64-bit x86 (same as X86-32+X86-64)
         XEN     Xen support is enabled
 
 In addition, the following text indicates that the option:
@@ -376,7 +378,7 @@ bytes respectively. Such letter suffixes can also be entirely omitted.
         atkbd.softrepeat= [HW]
                         Use software keyboard repeat
 
-        autotest        [IA64]
+        autotest        [IA-64]
 
         baycom_epp=     [HW,AX25]
                         Format: <io>,<mode>
@@ -681,8 +683,8 @@ bytes respectively. Such letter suffixes can also be entirely omitted.
                 uart[8250],mmio32,<addr>[,options]
                         Start an early, polled-mode console on the 8250/16550
                         UART at the specified I/O port or MMIO address.
-                        MMIO inter-register address stride is either 8bit (mmio)
-                        or 32bit (mmio32).
+                        MMIO inter-register address stride is either 8-bit
+                        (mmio) or 32-bit (mmio32).
                         The options are the same as for ttyS, above.
 
         earlyprintk=    [X86,SH,BLACKFIN]
@@ -725,7 +727,7 @@ bytes respectively. Such letter suffixes can also be entirely omitted.
                         See Documentation/block/as-iosched.txt and
                         Documentation/block/deadline-iosched.txt for details.
 
-        elfcorehdr=     [IA64,PPC,SH,X86]
+        elfcorehdr=     [IA-64,PPC,SH,X86]
                         Specifies physical address of start of kernel core
                         image elf header. Generally kexec loader will
                         pass this option to capture kernel.
@@ -791,7 +793,7 @@ bytes respectively. Such letter suffixes can also be entirely omitted.
                         tracer at boot up. function-list is a comma separated
                         list of functions. This list can be changed at run
                         time by the set_ftrace_filter file in the debugfs
-                        tracing directory. 
+                        tracing directory.
 
         ftrace_notrace=[function-list]
                         [FTRACE] Do not trace the functions specified in
@@ -829,7 +831,7 @@ bytes respectively. Such letter suffixes can also be entirely omitted.
 
         hashdist=       [KNL,NUMA] Large hashes allocated during boot
                         are distributed across NUMA nodes.  Defaults on
-                        for 64bit NUMA, off otherwise.
+                        for 64-bit NUMA, off otherwise.
                         Format: 0 | 1 (for off | on)
 
         hcl=            [IA-64] SGI's Hardware Graph compatibility layer
@@ -998,10 +1000,10 @@ bytes respectively. Such letter suffixes can also be entirely omitted.
                         DMA.
                 forcedac [x86_64]
                         With this option iommu will not optimize to look
-                        for io virtual address below 32 bit forcing dual
+                        for io virtual address below 32-bit forcing dual
                         address cycle on pci bus for cards supporting greater
-                        than 32 bit addressing. The default is to look
-                        for translation below 32 bit and if not available
+                        than 32-bit addressing. The default is to look
+                        for translation below 32-bit and if not available
                         then look in the higher range.
                 strict [Default Off]
                         With this option on every unmap_single operation will
@@ -1017,7 +1019,7 @@ bytes respectively. Such letter suffixes can also be entirely omitted.
                         off     disable Interrupt Remapping
                         nosid   disable Source ID checking
 
-        inttest=        [IA64]
+        inttest=        [IA-64]
 
         iomem=          Disable strict checking of access to MMIO memory
                 strict  regions from userspace.
@@ -1034,7 +1036,7 @@ bytes respectively. Such letter suffixes can also be entirely omitted.
                 nomerge
                 forcesac
                 soft
-                pt      [x86, IA64]
+                pt      [x86, IA-64]
 
         io7=            [HW] IO7 for Marvel based alpha systems
                         See comment before marvel_specify_io7 in
@@ -1165,7 +1167,7 @@ bytes respectively. Such letter suffixes can also be entirely omitted.
 
         kvm-amd.npt=    [KVM,AMD] Disable nested paging (virtualized MMU)
                         for all guests.
-                        Default is 1 (enabled) if in 64bit or 32bit-PAE mode
+                        Default is 1 (enabled) if in 64-bit or 32-bit PAE mode.
 
         kvm-intel.ept=  [KVM,Intel] Disable extended page tables
                         (virtualized MMU) support on capable Intel chips.
@@ -1202,10 +1204,10 @@ bytes respectively. Such letter suffixes can also be entirely omitted.
                         libata.dma=0      Disable all PATA and SATA DMA
                         libata.dma=1      PATA and SATA Disk DMA only
                         libata.dma=2      ATAPI (CDROM) DMA only
-                        libata.dma=4      Compact Flash DMA only 
+                        libata.dma=4      Compact Flash DMA only
                         Combinations also work, so libata.dma=3 enables DMA
                         for disks and CDROMs, but not CFs.
-        
+
         libata.ignore_hpa=      [LIBATA] Ignore HPA limit
                         libata.ignore_hpa=0       keep BIOS limits (default)
                         libata.ignore_hpa=1       ignore limits, using full disk
@@ -1331,7 +1333,7 @@ bytes respectively. Such letter suffixes can also be entirely omitted.
         ltpc=           [NET]
                         Format: <io>,<irq>,<dma>
 
-        machvec=        [IA64] Force the use of a particular machine-vector
+        machvec=        [IA-64] Force the use of a particular machine-vector
                         (machvec) in a generic kernel.
                         Example: machvec=hpzx1_swiotlb
 
@@ -1734,7 +1736,7 @@ bytes respectively. Such letter suffixes can also be entirely omitted.
 
         nointroute      [IA-64]
 
-        nojitter        [IA64] Disables jitter checking for ITC timers.
+        nojitter        [IA-64] Disables jitter checking for ITC timers.
 
         no-kvmclock     [X86,KVM] Disable paravirtualized KVM clock driver
 
@@ -1800,7 +1802,7 @@ bytes respectively. Such letter suffixes can also be entirely omitted.
 
         nox2apic        [X86-64,APIC] Do not enable x2APIC mode.
 
-        nptcg=          [IA64] Override max number of concurrent global TLB
+        nptcg=          [IA-64] Override max number of concurrent global TLB
                         purges which is reported from either PAL_VM_SUMMARY or
                         SAL PALO.
 
@@ -2077,7 +2079,7 @@ bytes respectively. Such letter suffixes can also be entirely omitted.
                         Format: { parport<nr> | timid | 0 }
                         See also Documentation/parport.txt.
 
-        pmtmr=          [X86] Manual setup of pmtmr I/O Port. 
+        pmtmr=          [X86] Manual setup of pmtmr I/O Port.
                         Override pmtimer IOPort with a hex value.
                         e.g. pmtmr=0x508