Linux-2.6.12-rc2v2.6.12-rc2

Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.

Let it rip!

1 files changed, 41 insertions, 0 deletions

diff --git a/Documentation/sound/oss/PSS b/Documentation/sound/oss/PSS
new file mode 100644
index 000000000000..187b9525e1f6
--- /dev/null
+++ b/Documentation/sound/oss/PSS
@@ -0,0 +1,41 @@
+The PSS cards and other ECHO based cards provide an onboard DSP with 
+downloadable programs and also has an AD1848 "Microsoft Sound System" 
+device. The PSS driver enables MSS and MPU401 modes of the card. SB 
+is not enabled since it doesn't work concurrently with MSS. 
+
+If you build this driver as a module then the driver takes the following
+parameters
+
+pss_io.         The I/O base the PSS card is configured at (normally 0x220
+                or 0x240)
+
+mss_io          The base address of the Microsoft Sound System interface.
+                This is normally 0x530, but may be 0x604 or other addresses.
+
+mss_irq         The interrupt assigned to the Microsoft Sound System
+                emulation. IRQ's 3,5,7,9,10,11 and 12 are available. If you
+                get IRQ errors be sure to check the interrupt is set to 
+                "ISA/Legacy" in the BIOS on modern machines.
+
+mss_dma         The DMA channel used by the Microsoft Sound System.
+                This can be 0, 1, or 3. DMA 0 is not available on older 
+                machines and will cause a crash on them.
+
+mpu_io          The MPU emulation base address. This sets the base of the
+                synthesizer. It is typically 0x330 but can be altered.
+
+mpu_irq         The interrupt to use for the synthesizer. It must differ
+                from the IRQ used by the Microsoft Sound System port.
+
+
+The mpu_io/mpu_irq fields are optional. If they are not specified the 
+synthesizer parts are not configured.
+
+When the module is loaded it looks for a file called 
+/etc/sound/pss_synth. This is the firmware file from the DOS install disks.
+This fil holds a general MIDI emulation. The file expected is called
+genmidi.ld on newer DOS driver install disks and synth.ld on older ones.
+
+You can also load alternative DSP algorithms into the card if you wish. One
+alternative driver can be found at http://www.mpg123.de/
+