i2c-i801: Enable IRQ for SMBus transactions

Add a new 'feature' to i2c-i801 to enable using PCI interrupts.
When the feature is enabled, then an isr is installed for the device's
PCI IRQ.

An I2C/SMBus transaction is always terminated by one of the following
interrupt sources: FAILED, BUS_ERR, DEV_ERR, or on success: INTR.

When the isr fires for one of these cases, it sets the ->status variable
and wakes up the waitq.  The waitq then saves off the status code, and
clears ->status (in preparation for some future transaction).
The SMBus controller generates an INTR irq at the end of each
transaction where INTREN was set in the HST_CNT register.

No locking is needed around accesses to priv->status since all writes to
it are serialized: it is only ever set once in the isr at the end of a
transaction, and cleared while no interrupts can occur.  In addition, the
I2C adapter lock guarantees that entire I2C transactions for a single
adapter are always serialized.

For this patch, the INTREN bit is set only for SMBus block, byte and word
transactions, but not for I2C reads or writes.  The use of the DS
(BYTE_DONE) interrupt with byte-by-byte I2C transactions is implemented in
a subsequent patch.

The interrupt feature has only been enabled for COUGARPOINT hardware.
In addition, it is disabled if SMBus is using the SMI# interrupt.

Signed-off-by: Daniel Kurtz <djkurtz@chromium.org>
Signed-off-by: Jean Delvare <khali@linux-fr.org>

1 files changed, 10 insertions, 3 deletions

diff --git a/Documentation/i2c/busses/i2c-i801 b/Documentation/i2c/busses/i2c-i801
index 71f55bbcefc8..615142da4ef6 100644
--- a/Documentation/i2c/busses/i2c-i801
+++ b/Documentation/i2c/busses/i2c-i801
@@ -38,9 +38,10 @@ Module Parameters
 Disable selected features normally supported by the device. This makes it
 possible to work around possible driver or hardware bugs if the feature in
 question doesn't work as intended for whatever reason. Bit values:
-  1  disable SMBus PEC
-  2  disable the block buffer
-  8  disable the I2C block read functionality
+ 0x01  disable SMBus PEC
+ 0x02  disable the block buffer
+ 0x08  disable the I2C block read functionality
+ 0x10  don't use interrupts
 
 
 Description
@@ -86,6 +87,12 @@ SMBus 2.0 Support
 The 82801DB (ICH4) and later chips support several SMBus 2.0 features.
 
 
+Interrupt Support
+-----------------
+
+PCI interrupt support is supported on the 82801EB (ICH5) and later chips.
+
+
 Hidden ICH SMBus
 ----------------